Finder IB152KEN Operating instructions

Brand: Finder

Model: IB152KEN

Type: Operating instructions

Finder IB152KEN is a 2-channel KNX dimmer that allows you to control the brightness of your LED or incandescent lights using your KNX home automation system. It features manual control buttons, thermal and short circuit protection, scenario management, and individual ID LEDs for each output.

0.5 Nm

7mm

(1x6/2x2.5) mm2

(1x10/2x14) AWG

7mm

1x4/2x1.5) mm2

(1x12/2x16) AWG

1a 1b

88.8 mm

60.8 mm

70 mm

15.2K.8.230.0400

IN BUS KNX 29 V DC

(21...32 V DC) SELV

Pmax 2 x 400 W max

CH1

CH2

LED (230 V AC) 100 W

(230 V AC) 400 W

(230 V AC) 100 W

(230 V AC) 400 W

(–5...+45)°C

IP20

Utility Model - IB152KVXX - 11/19

FINDER S.p.A. con unico socio - 10040 ALMESE (TO) - ITALY

15.2K

ENGLISH

15.2K DIMMER KNX (2 channels)

FRONT VIEW

1a Channel 1 (CH 1)

1b Channel 2 (CH 2)

1c Button for manual increase

1d Green LED, output ON

1e Red LED, overload

1f Buttons for manual decrease

1g Power supply via KNX BUS

1h PROG: press the button to enter programming mode (Red LED ON)

TEST: test button. Press the button for 3 seconds (yellow LED flashes)

to enable the 1C / 1F outputs keyboard.

To disable it, press the button once (yellow LED OFF).

After enabling the manual function with the TEST key, with the

UP(+)/DOWN(–) keys of the individual channels it is possible to

switch on the lights in steps of 30%. During the TEST mode, the

command telegrams from the bus are ignored

WIRING DIAGRAM

PRODUCT FEATURES

- Leading Edge or Trail Edge adjustment method settable by ETS 4

- Manual control of each channel via front panel

- Thermal protection and short circuit protection

- Scenario management

- ID LED for each output

NOTE

- The product must not be used for safety functions

- Environmental class according to EN 50491-2: Protected by climate

in uncontrolled conditions, temperature –25...+45°C

Check the correct address of the device and the setting of the parameters,

via ETS software

- EN 60669-1 and 60669-2-1/EN 50491

- 35 mm bar mounting (EN60715)

- Width 70 mm (4 modules)

CAUTION

The individual dimmer channels and the BCU are supplied separately,

in case of non-simultaneous power supply an initialization time which

can last up to 20“ is required.

During this phase, the commands received will not be considered.

Finder IB152KEN Operating instructions

Finder IB152KEN Operating instructions

Finder IB152KEN Operating instructions

Other documents