2. Sioux Chief
  3. 822-C4PNR

Sioux Chief 822-C4PNR Installation guide

  • Hello! I've reviewed the installation instructions for the Sioux Chief 822 Series Floor Drain with Deck Flange. This document provides detailed guidance on installing the drain in wood and concrete settings, including specific information about hole sizes, flange securing, pipe connections, and drain head adjustments. I am ready to answer any questions you have about its installation process or features.
  • What size hole is needed for the wood deck installation?
    What is the recommended method to secure the stainless steel flange on wood deck?
    How high will the Finish Line sleeve/plug assembly set above the concrete surface?
    Can the drain head be adjusted after installation?
Installation Instructions
822 Series Floor Drain with Deck Flange
Typical Installation on Wood Deck
Solvent Weld Connection
Sioux Chief Manufacturing
1-800-821-3944 • www.siouxchief.com
Installation Notes:
• Solvent weld joints should be made per
solvent cement/DWV pipe manufacturer’s
instructions. Follow manufacturer’s
instructions for installation of no-hub
couplings.
• Installation of drain ange on underside of
wood or metal decks is NOT recommended.
• Always be sure to check and follow all local
plumbing codes.
Typical Installation in Cored Concrete
No-Hub Connection
Installation of Finish Line Option
(cored concrete application)
Cut a 6" round hole in wood deck and secure stainless
steel ange to top surface with six screws or nails
Solvent weld ABS or PVC DWV pipe into hub of drain body.
Enclosure of 3" P-traps (shown) in oor/ceiling joist requires a 12"
joist cavity. Drain head may be adjusted up to ¾" above suboor.
Enclosure of 2" P-traps (shown) in oor/ceiling joist
requires a 10" joist cavity. Use minimal adjustment
for thinner nished oor coverings.
Holes in precast concrete oors should be 6" straight
diameter (not stepped). Secure stainless steel ange with
six screws for concrete surfaces. If necessary, connect
no-hub coupling to drain outlet before installation
After installation, drain head may be adjusted up to ¾" above
concrete surface to accommodate nished oor veneer.
1"
Install drain and secure stainless steel ange as described. Finish
Line sleeve/plug assembly will set 1" above concrete surface.
Finish secondary (or lightweight) concrete pour ush
with top surface of sleeve/plug assembly.
Remove Finish Line plug and replace with
drain xture when ooring is installed.
/