Oil change and inspection now!
OIL CHAN_ AND INSPECTION NOW
Displaying the distance and days until the next service interval
›
Switch on the ignition.
›
Press the button
6
» Fig. 2 on page 9 and keep it pressed down until Service
appears.
›
Release the button
6
.
The icon appears in the display, as well as the following message for example.
Service in ... km or... days.
SERVICE IN ... km OR... DAYS
Resetting Service Interval Display
If the variable service interval is set in your vehicle and if the service interval dis-
play is reset, the variable service interval is switched to the fixed service interval.
We therefore recommend that the Service Interval Display be reset only by a spe-
cialist garage, which will reset the display with a vehicle diagnostic tester.
Reset - oil change service
›
Switch off the ignition (for vehicles with the KESSY system all doors as well as
the luggage compartment and bonnet flaps must also be shut).
›
Press the button
6
» Fig. 2 on page 9 and keep it pressed down.
›
Switch on the ignition, the following message displays.
Reset oil change service?
RESET OIL SERVICE
›
Release and then press again the button
6
.
Reset - Inspection
›
Switch off the ignition (for vehicles with the KESSY system all doors as well as
the luggage compartment and bonnet flaps must also be shut).
›
Press the button
6
» Fig. 2 on page 9 and keep it pressed down.
›
Switch on the ignition and keep button
6
pressed down until the following
message displays.
Reset inspection service – are you sure?
RESET SERVICE
›
Release and then press again the button
6
.
CAUTION
We recommend that you do not reset the service interval display yourself. Incor-
rectly setting the service interval display could cause problems to the vehicle.
Note
■
Information is retained in the Service Interval Display even after the vehicle bat-
tery is disconnected.
■
If the instrument cluster is exchanged after a repair, the correct values must be
entered in the counter for the Service Interval Display. We recommend having this
work undertaken by a ŠKODA service partner.
■
For more information on the service intervals » service schedule, chapter serv-
ice intervals.
Auto-check control
First read and observe the introductory information and safety warn-
ings on page 9.
Certain functions and conditions of individual vehicle systems are checked contin-
uously when the ignition is switched on.
Error messages and/or other information are displayed in the instrument cluster
display.
Some messages are displayed simultaneously with the warning lights » page 14
or warning icons in the display » page 20.
While the operational faults remain unrectified, the messages are always indica-
ted again. After they are displayed for the first time, the symbols
or
continue
to be indicated without any extra messages for the driver.
Symbol Description
Warning
Danger
WARNING
If you have to stop for technical reasons, then park the vehicle at a safe dis-
tance from the traffic, switch off the engine and activate the hazard warning
light system » page 57. The warning triangle must be set up at the prescri-
bed distance - observe the national legal provisions when doing so.
13
Instruments and warning lights