Page is loading ...
HanoverOutdoorFurniture
IMPORTANT
Ifyouhaveanyproblemswiththisproduct(missingordamagedparts,assemblyissues,etc.),
PLEASEDONOTRETURNTOTHERETAILER/STORE
fromwhereyoupurchasedtheproduct.
PleasecallourToll‐FreeCustomerServiceHotlineat:
1‐800‐416‐3511
Between9:00AMand5:00PMEasternTime,MondaythroughFriday
Orvisitourwebsiteat:
www.hanover‐products.com
Toexpediteanyfuturewarrantyclaims,pleaseretaintheInstructionSheet,Warranty
Cardandreceiptforfutureuse.
For additionalon‐linesupportonassembly,troubleshootingandcare&maintenanceofyouroutdoor
furniture,pleasevisitourwebsiteat:www.hanover‐products.com.
6/1/2015(a)
Page 4
ASSEMBLY INSTRUCTIONS
1
2
From behind the chaise lounge back frame, insert a bolt with Ø8.5x1.5 mm washer through the hole in the lower
sling back frame. Add a Ø15x4 mm plastic washer before inserting into the fixed nut in side the sling seat frame
(see diagram). . Completely tightening at this point could cause the frame or
the sling seat to be uneven. Repeat for the opposite side.
Hand tighten 3-4 revolutions only
Using the hex wrench provided, tighten bolts. Tighten each bolt a few revolutions at time, alternating back
and forth between the two bolts until they are completely tightened. It is important to alternate between bolts
to ensure your frame and sling seat are even. . Over tightening could damage the threads
on the bolts or nuts.
Do not over tighten
D
E
C
A
B
FOOT CAP
Page 5
*NOTE:PARTSSHOWNONPARTSLISTARENOTTOSCALE
PARTS IDENTIFICATION LIST
5/16" X 42 MM BOLT
HW0809
2
2
Ø15X4MMPLASTIC
WASHER
HW0026
ADJUSTMENT BAR
FACTORY ASSEMBLY
BUMPER
FACTORY ASSEMBLY
HW0078
SLING SEAT FRAME
1
1
SLING BACK FRAME
PARTS LIST DESCRIPTION ORDER PART #
QTY
A
B
C
D
E
F
2
Ø8.5 X 1.5 MM
WASHER
HW0005
SLING TUBE CAP-2
FACTORY ASSEMBLY
FC0468
HEX BOLT DRIVER
1
HW0006
FC0030
FOOT CAP
FACTORY ASSEMBLY
SLING TUBE CAP 1-
FACTORY ASSEMBLY
FC0005
ADL17002
AL1584
AL1585
AL1586
/
