2-4
Daily Management and Maintenance > Improving and maintaining of print quality
Adjusting Printable Ink Temperature
When the power is turned on, if the temperature of the ink in the print head nozzle is low, sleep is recovered, or ink is
replaced in a low temperature environment, white streaks occur due to the viscosity of the ink, and the image
deteriorates. There are two methods to avoid this problem: switching the priority mode from [Print] to [Quality] and
changing the lower limit temperature for print.
Switching the priority mode from [Print] to [Quality]
1
[Home] key > [...] > [Professional Settings] > [U735 Set Ink
Temperature Control] > [01 Mode]
2
[Quality] > [Start] key > [Stop] key
When print mode is [Quality], the printable temperature range is [A1] to [B2]. On the other
hand, When print mode is [Printing], the printable temperature range is [A1] to [C2].
3
Select [Close]
The professional settings close.
Item Description
01 Non Cap When the power is turned on, the print head cap is removed and
printing can be started immediately. The heater in the Inverter and
Decurler Unit is off. Select this item to prioritize printing over
quality.
02 Cap(Non Heater) When turning on the power, leave the print head cap in place and
remove the cap at the start of printing.
03 Cap(Heater) When the power is turned on, the print head is kept capped and
the temperature in the Inverter and Decurler Unit stands by until
the temperature rises for printing. The cap is removed when the
printing is ready. Select this item to prioritize print quality.
04 Auto The operation changes depending on the off/on state of the heater
inside of Inverter and Decurler unit.
When the heater inside of Inverter and Decurler is off: When the
power is turned on, leave the cap on the print head and wait until
the temperature in the Inverter and Decurler rises to printable.
When the heater inside of Inverter and Decurler is on: When the
power is turned on, the print head cap is removed and printing can
be started immediately.
When switching to [Quality], you can not configure the lower limit temperature for print.