1
Cables to Cameras
• Video - Yellow to Yellow
• Power - Red to Red
• IMPORTANT! WRAP CONNECTIONS
WITH ELECTRICAL TAPE!
2
Splitter to Power Adapter
3
Cables to Splitter/DVR
Power - Red to Splitter
Video - Yellow to Video Output
DO NOT PLUG IN OR MOUNT CAMERAS YET!
4
Monitor or TV to DVR
5
Mouse to DVR
6
Power Adapter to DVR
7
Power to Surge Protector
Plug in Monitor and Adapters
8
Setup Wizard
• Click Next
• REQUIRED! CREATE USER NAME.
CREATE PASSWORD USING
EXACTLY 8 NUMBERS, click Next
• If information for HDD, Network,
Email, and/or Record Schedule is
unknown, click Next to skip them
• Stop at General System Configuration
and enter date and time
• Click Save
9
Test and Mount Cameras
R
R
R
R
02/17/2018 09:23:14 AM
CH1
CH3
CH4
CH2
• IMPORTANT! VIEW CAMERAS
ON MONITOR TO MAKE SURE
THEY ARE WORKING PROPERLY
BEFORE MOUNTING THEM!
• Place cameras under eaves and cable
connections inside walls to shelter
them from rain and direct sunlight
• Mount cameras using supplied hardware
Default Settings
• Every camera will record all the time:
R
will show on screen and red
HDD light on DVR will blink
• Motion detected recording will be OFF:
M
will show on screen if motion is
detected, but DVR will not record
• Camera Recording Resolution will
be set to 1920 x 1080, FPS will
be 15, and Bitrate will be 4096
Please Refer to Owner’s
Manual to Change Settings
This Quick Start Guide is not
intended to replace the Owner’s
Manual & Safety Instructions. To
prevent serious injury, read all
safety warnings and instructions
therein to ensure proper usage.
18d
What you will need (sold separately):
• Monitor or TV with VGA or HDMI Input and Cable • Surge Protector with 3 Dedicated Outlets
63890
Basic Set up Quick Start Guide
8 Channel
SURVEILLANCE
DVR with 4 HD Cameras
With Mobile Monitoring Capabilities
1
Connect DVR to Router
• Connect one end of Ethernet Cable to LAN port on DVR
• Connect other end to open LAN port on Router
2
Go to Parameter > Network
• Make sure DHCP is selected, then click Save
• IP Address, Subnet Mask, Gateway and
DNS1 should automatically fill in
• Enable UPNP, then click Save
3
Install RXCamView app to Mobile Device
• For Android, go to Google Play Store
• For Apple, go to App Store
• Download and open app
• Tap Device icon
• Tap + to add device
• Tap Manual to manually input information from DVR
• Device Name: Name the Device (Optional)
• Login Type: Device ID
• Tap QR Code and point device at ID QR Code on
top of DVR or manually enter the ID number
• Media Port: 9000
• User Name: Use DVR User Name (case sensitive)
• Password: Use DVR Password (exactly 8 numbers)
• Click Save
If system fails to connect you will need to
contact your Internet Service Provider
What you will need (sold separately):
• High Speed Internet • Router
• Ethernet Cable • Mobile Device with Android or IOS
63890
IMPORTANT! YOU MAY NEED TO CONTACT YOUR INTERNET SERVICE PROVIDER TO SET UP THE NETWORK!
Basic DHCP Network Setup Quick Start Guide
8 Channel
SURVEILLANCE
DVR with 4 HD Cameras
With Mobile Monitoring Capabilities
/