Truck Slide 4312-003 Installation guide

Brand: Truck Slide

Model: 4312-003

Type: Installation guide

This manual is also suitable for

NOTE:

505-00033 TRUCK SLIDE MAT SHOWN.

OTHER CONFIGURATIONS WILL VARY SLIGHTLY,

BUT WILL NOT AFFECT ASSEMBLY.

DRILL/ DRIVER

Rev. AA

Installation Instructions: TRUCK SLIDE MAT

PART# 505-00033

SAFETY GLASSES TAPE MEASUREDRIVER BIT SET

person is required for lifting and installing of this product.

Pg. 1

Attention Read all instructions and understand all warnings before installing or using this product.

Notes

Do not over tighten hardware.

Tools Required

•

Perform all work on dry level ground.•

Insure vehicle's parking break is engaged and wheels are

chocked.

•

Use safety glasses when using tools or working under vehicle.• Due to the size and weight of products more than one •

Danger of Injury

Team lift is required for installation of this product.

Moving parts in this assembly can cause injury.

PART# 505-00033

Installation Instructions: TRUCK SLIDE MAT

Rev. AA

Note: Take inventory of all

provided parts prior to assembly.

Pg. 2

Provided Parts

ITEM

NO.

PART NUMBER QTY.

1 040-05062, DIAMOND RUBBER MAT 1

2 285-00213, 5/8" X 48" ANGLE 2

3 030-05014, 10-16X1" SELF TAP SCREW 8

Rev. AA

Installation Instructions: TRUCK SLIDE MAT

PART# 505-00033

Pg. 3

STEP 1:

PLACE RUBBER MAT DIAMOND PLATE

SIDE UP IN TRUCK SLIDE

AS SHOWN IN FIGURE 1

STEP 2:

ALIGN MAT WITH REAR CORNERS OF

TRUCK SLIDE

AS SHOWN IN FIGURE 2

STEP 3:

PLACE 5/8" ANGLE ON TOP OF RUBBER MAT

AND AGAINST REAR FACE OF TRUCK SLIDE

AS SHOWN IN FIGURE 3

FIGURE 2

FIGURE 1

FIGURE 3

REAR FACE OF TRUCK SLIDE

RUBBER MAT

5/8" ANGLE

RUBBER MAT

TRUCK SLIDE REAR FACE

SCREW 10-16X1"

SELF TAPPIING

FIGURE 4.2FIGURE 4.1

SELF TAP SCREW LOCATIONS

FIGURE 5

Rev. AA

Installation Instructions: TRUCK SLIDE MAT

PART# 505-00033

Pg. 4

STEP 4:

FIRMLY HOLD DOWN ANGLE AND SECURE

IN PLACE WITH SELF TAPPING SCREWS (QTY 4)

AS SHOWN IN FIGURE 4.1 AND 4.2

STEP 5:

PULL MAT TIGHT AND ALIGN WITH

FRONT EDGE OF TRUCK SLIDE

AS SHOWN IN FIGURE 5

RUBBER MAT

FRONT EDGE

SCREW 10-16X1"

SELF TAPPIING

FIGURE 6

5/8" ANGLE

FIGURE 7.1

FIGURE 7.2

RUBBER MAT

Installation Instructions: TRUCK SLIDE MAT

Rev. AAPART# 505-00033

Pg. 5

STEP 6:

CAPTURE FRONT EDGE OF MAT WITH

5/8" ANGLE AND LOCATE

AS SHOWN IN FIGURE 6

STEP 7:

FIRMLY HOLD DOWN ANGLE AND SECURE

IN PLACE WITH SELF TAPPING SCREWS (QTY 4)

AS SHOWN IN FIGURE 7.1 AND 7.2

SELF TAP SCREW

LOCATIONS

Truck Slide 4312-003 Installation guide

Truck Slide 4312-003 Installation guide

This manual is also suitable for

Truck Slide 4312-003 Installation guide

Other documents