Innova PF6003-SS Installation guide

Innova
Brand
Innova
Model
PF6003-SS
Category
Sanitary ware
Type
Installation guide

This manual is also suitable for

DIAGRAM AND PART LIST
KITCHEN FAUCET
PF6003-SS
Recommended Tools and MaterialsRECOMMENDED TOOLS AND MATERIALS
BEFORE YOU BEGIN
CAUTION: Risk of restricted water flow and product damage. Use extreme
care when connecting all hoses to avoid kinking and twisting.
Risk of fresh water contamination. This faucet contains important back
siphon protection. Do not tamper with or remove any components.
•Shut off the main water supply.
•Observe local plumbing codes.
•Inspect the supply tubing for any damage. Replace as necessary.
•Except for plumbers putty on the undercover or escutcheon, do not use
petroleum based products on this faucet.
•PF WaterWorks reserves the right to make revisions in the design of faucets
without notice.
1
2
3
4
5
6
7
8
9
10
12
11
1
Spray Wand
Faucet Body
2
3
Hot & Cold Water Lines
Outlet Hose
5
Escutcheon
6
Rubber Washer
9
Metal Washer
10
Mounting Kit
11
Quick Nut (Optional)
12
4
Pull-down Hose
7
Putty Plate
8
Weight
INSTALLATION INSTRUCTIONS
You can install this faucet using standard faucet nut or QuikNut.
Below Instruction 3A is for normal mounting nut installation.
If your faucet came with Optional QuikNut, please see 3B for QuikNut Installation.
1
Unscrew the pre-assembled Washers(9,10) &
Mounting Kit(11).
9
10
11
3A
Slide Rubber Washer(9), Metal Washer(10) then
Mounting Kit(11) up onto Faucet Body(2) under
sink and secure with Mounting Kit(11).
Use screw driver to tighten the Mounting Kit(11)
firmly. Afterwards check if the Faucet Body(2) is
well fixed.
9
10
11
11
11
6,7
2
Install with or without Escutcheon(6) & Putty
Plate(7), please refer to fig A or fig B
Note: Do not use petroleum-based plumeber’s
putty on marble or srone surface.
A B
Slide Rubber Washer(9), Quick Nut (12) up onto
faucet body under sink.
Hold the Quick Nut (12) and rotate the Quick
Nut (12), two rounds to tighten the nut.
Pictures for reference only
9
12
9
12
3B
INSTALLATION INSTRUCTIONS
4
3
Attach water Supply Lines(3) to angle valves.
6
Install the Weight(8) to cover the weight label
on the Pull-Down Hose(4).
Note: Do not kink the hose
4
8
5
Connect the Outlet Hose(5) to the Pull-Down
Hose(4) with quick connector.
To Disconnect the Hose
4
5
Hold the Quick Nut (12) turn the Quick Nut (12),
counter clockwise for two rounds, then pull it
down directly.
3C
Pictures for reference only
9
9
12
12
For quick nut disassembly
INSTALLATION INSTRUCTIONS
a. Unscrew Spray Wand(3) by anticlockwise
direction, turn on angle valves. Pull the handle to
the right to turn on water for 15 seconds to flush
any debris.
b. Afterwards install the spray wand and check if
anywhere leaking.
7
A
B
PF WaterWorks Faucet Limited Lifetime Warranty
This warranty applies only to PF WaterWorks Faucets installed in the United States of America, Canada or Mexico ("North America").
Parts
All parts (other than electronic parts and batteries) of this PF WaterWorks faucet (except gold, non-vibrant, non-chrome finishes) are
warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer
purchaser owns the home in which the faucet was first installed or, for commercial users, for one (1) year from the date of original
purchase (receipt required for verification). Faucets with Polished Gold, non-Vibrant and painted or powder coated finishes, are
warranted to the original consumer purchaser to be free from defects in material and workmanship for one (1) year from the date of
purchase or, for commercial users, for one (1) year from the date of purchase (receipt required for verification).
Electronic Parts and Batteries (if applicable)
Electronic parts (other than batteries), if any, of the PF WaterWorks faucet are warranted to the original consumer purchaser to be free
from defects in material and workmanship for one (1) year from the date of purchase or, for commercial users, for one (1) year from the
date of purchase. No warranty is provided on batteries.
What We Will Do
If a defect is found in normal installation, use and service, PF WaterWorks will, at its election, repair, provide a replacement part or
product, or make appropriate adjustment. Proof of purchase (original sales receipt) along-with the defective product must be provided to
PF WaterWorks with all warranty claims. PF WaterWorks is not responsible for labor charges, installation, shipping, or other incidental or
consequential costs. In no event shall the liability of PF WaterWorks exceed the purchase price of the Faucet. In case of Faucet
purchased from a reseller, any refunds or returns will need to be handled directly with the reseller. PF WaterWorks cannot offer refund for
faucets not purchased directly from PF WaterWorks. These are your exclusive remedies.
What Is Not Covered
Any labor charges incurred by the purchaser to repair, replace, install, remove or ship this product are not covered by this warranty. PF
WaterWorks shall not be liable for any damage to the faucet resulting from reasonable wear and tear, misuse, abuse, neglect, accident,
or improper or incorrectly performed installation, maintenance or repair, including failure to follow the applicable care and cleaning
instructions. PF WaterWorks recommends using a professional plumber for all installation and repair. We also recommend that you use
only genuine PF WaterWorks replacement parts.
Never use cleaners containing abrasive cleansers, ammonia, bleach, acids, waxes, alcohol, solvents or other products not
recommended for chrome. This will void the warranty.
What You Must Do To Obtain Warranty Service or Replacement Parts
A warranty claim may be made and replacement parts may be obtained by writing to [email protected]. Proof of
purchase (original sales receipt) from the original purchaser must be made available to PF WaterWorks for all warranty claims.
Limitation on Duration of Implied Warranties. TO THE EXTENT PERMITTED BY LAW, ANY IMPLIED WARRANTY,
INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED
TO THE STATUTORY PERIOD OR THE DURATION OF THIS WARRANTY, WHICHEVER IS SHORTER. Some states/provinces do not
allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
Limitation of Special, Incidental or Consequential Damages. PF WATERWORKS SHALL NOT BE LIABLE FOR ANY
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING LABOR CHARGES TO REPAIR, REPLACE, INSTALL OR
REMOVE THIS PRODUCT), WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED WARRANTY, BREACH OF
CONTRACT, TORT, OR OTHERWISE. PF WATERWORKS SHALL NOT BE LIABLE FOR ANY DAMAGE TO THE FAUCET
RESULTING FROM REASONABLE WEAR AND TEAR, MISUSE, ABUSE, NEGLECT OR IMPROPER OR INCORRECTLY
PERFORMED INSTALLATION, MAINTENANCE OR REPAIR, INCLUDING FAILURE TO FOLLOW THE APPLICABLE INSTALLATION,
CARE AND CLEANING INSTRUCTIONS. Some states/provinces do not allow the exclusion or limitation of special, incidental or
consequential damages, so the above limitations and exclusions may not apply to you.
Additional Rights
This warranty gives you specific legal rights, and you may also have other rights which vary from state/province to state/province.
This is PF WaterWorks’ exclusive written warranty and the warranty is not transferable.
If you have any questions or concerns regarding our warranty, please email us as provided above or visit us at www.pfwaterworks.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Innova PF6003-SS Installation guide

Innova
Brand
Innova
Model
PF6003-SS
Category
Sanitary ware
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents