www. RSIWW.com customerservice@rsiww.com
RSI 18 Inch Louver Wall
Mounted Window
RSI-WV
Install Instructions
www. RSIWW.com customerservice@rsiww.com
Locate location between Greenhouse or wall supports to place the RSI- Wall Vent.
Mark Back of Shutter 18.25 inches square opening to be cut out for RSI – Wall Vent Placement.
www. RSIWW.com customerservice@rsiww.com
Remove RSI- Wall Vent to expose corner marks of where the Wall Vent will go.
Cut opening with Razor knife or hack saw. Make sure to cut all the way through.
www. RSIWW.com customerservice@rsiww.com
18.25” square finished cut out.
Hold RSI – Wall Vent in place and drill mounting holes. The frame should be facing the inside of the greenhouse and the
vent with louvers should be facing the outside of the greenhouse or structure.
www. RSIWW.com customerservice@rsiww.com
Install quarter inch bolts and washers. (INSIDE).
Finished installed bolts and washers (OUTSIDE WILL HAVE NUTS THAT THE BOLTS ARE ATTACHED TO).
www. RSIWW.com customerservice@rsiww.com
Install AUTOMATIC Opener to opener arm on Wall Vent (INSIDE).
Install Opener Linkage to frame of wall vent (INSIDE).
www. RSIWW.com customerservice@rsiww.com
Install Complete.
Thank you for your business.
/
