Page is loading ...
SIDE VIEW
TOP BRACKET
FRONT VIEWS T E P 1
64"
BOTTOM BRACKET
SIDE VIEW
A
B
STEP 1: B R A C K E T I N S T A L L A T I O N
-Position the brackets according to the drawing below.
-Measure from the bottom hole of the top bracket 64" to the top hole of the bottom bracket.
FRONT VIEW
28 1/2"
SIDE VIEW
64"
A
B
64"
STEP 2: B R A C K E T I N S T A L L A T I O N
-Measure from the center of bracket (A) 28 1/2" to the center of the bracket (B).
A
B
-Insert the drywall anchors into the wall. Attach the bracket with the screws.
A
C
D
D
1 2
D
D
3
SIDE VIEW
A
B
4
C
D
D
1 2
B
STEP 3: C A B L E I N S T A L L A T I O N
-NOTE: Make sure the TENSIONER is located at the bottom. Refer to the image below.
-Install the cable by inserting the pin (C) through both the hole of the clevis and bracket.
-Lock the pin (C) with the clip (D).
FRONT VIEW
-Do not tension the cables yet.
64"
SIDE VIEW
A
B
16"
16"
16"
16"
A B
cable clamp
cable clamp
cable clamp
1 23
STEP 4: C L A M P S I N S T A L L A T I O N
-Apply tension to the back cable (A) by turning the tensioner at the bottom. See STEP 6 for more information.
-Do not over tension the cables (A). Apply just enough tension to keep the cables straight.
-Lock the pin (C) with the clip (D).
-Install the clamp on cable (A) according to the image below.
SIDE VIEW
A
B
FRONT VIEW
cable clamp
cable clamp
cable clamp
A
B
1 2
1
2
3
4
5
6
STEP 5: S H E L F I N S T A L L A T I O N
-Install the top shelf on top of the clamp of cable (A).
-Slide the cable (B) through the front slots of the top shelf.
-Pull the cable down with your hands.
-Level the shelf and install the front clamps on cable (B).
-Repeat this process with the remaining shelves.
SIDE VIEW
C
D
A
B
X
A
B
C
D
A
B
X
A
B
STEP 6: T E N S I O N T H E C A B L E S
-Apply tension to the cables by turning clockwise the bottom fitting.
-Lock the thread with the nut.
-Hold the fitting with a wrench in the spot marked with an (X) below if necessary.
FRONT VIEW
cable clamp
cable clamp
cable clamp
1
2
3
STEP 7: A D J U S T M E N T S.
-Adjust the shelves by moving the clamps up and down the cable if necessary.
/
