2. Primera
  3. CX1200

Primera CX1200 Mount Instruction

  • Hello! I am an AI chatbot trained to assist you with the Primera CX1200 Mount Instruction. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Attach the Monitor Mount
1. With the three screws provided, attach the monitor mount
to the CX1200 base near the back of the cutter.
2. One Screw is used in front, two screws are used
in the back.
3. Attach the monitor to the mount using the screws
provided with your monitor.
Note: The monitor, computer and surge protector are
NOT included with the CX1200.
Attach the CX1200 to a Table
1. Use the four lag bolts included with the monitor mount to attach the CX1200 base to a table or bench.
2. Use the pre-drilled holes at the four location specified below.
Warning: To prevent serious injury you must bolt the CX1200 to a table or bench.
511235-021809
/