YukiHalu YUKIHALU-02 User guide

Type
User guide

This manual is also suitable for

Rematch signal between remoter and receiver
Step 1: power on the receiver (120V/60HZ ON)
Step 2: push “ stop” and “8H” button at same time.
Keep push the two button for 3 seconds, after the
indicator lamp change the brightness (became dark)
and then both release.
Step 3: push “ LIGHT ON/OFF” key quickly several
times, if the light can on/off, match finished.
Step 4: if light can not on/off, repeat step1 to step3
Note: all operate should be finished in 60 seconds
after power on
  • Page 1 1

YukiHalu YUKIHALU-02 User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages