RUNNUR TBC-U-KIT Installation guide

8. Wait 72 hours allowing both mounts to fully bond.

9. Insert Buckle plate into mount

10. Attach key ring to tether plate.

11. Attach hip pad to belt

12. Attach security cord to D-ring on hip pad.

13. Lock Case to hip.

5. Remove buckle from mounting plate, then peel sticker

from mounting plate and stick to case. Press hard for 15

seconds.

6. Reuse alcohol wipe to clean area at bottom center of

case where tether plate is to be attached.

7. Peel sticker from tether plate and mount at bottom

center of case. Press hard for 15 seconds.

1. Clip Buckle Plate into Mounting Plate

2. Center Mounting plate on tablet case so that the bend

in the buckle plate is right at top edge of case.

3. Use pen or pencil to mark edges of mounting plate

4. Use alcohol wipe to clean tablet case where mounting

plate is to be attached. Keep alcohol wipe handy for

further use.

BeltClip Assembly Instructions

For video instructions visit our youtube channel :

RUNNUR : Mobile Tech Gear

Download PDF