![](//vs1.manuzoid.com/store/data-gzf/3f38c2082945ccee11503c461cd6fabd/2/000493840.htmlex.zip/bg8.jpg)
Clip ends must be
aligned as close to
end connectors of lamp
tube when installed. Do NOT
allow to touch tube lamp itself.
2 sheet metal
Screws
6 small
bolts
Connecting wire
lead
Metal friction clips
Push apart sligtly
to remove
lamp tube end
connectors
Front Vent Panel
Remove & Replace ENTIRE Lamp assembly
including lamp, end connectors & wire lead
NOTE: do NOT allow any metal to contact actual lamp tube
End
connectors
wire lead
terminal connector