Scotsman Nugget Ice & Dispenser Kit KFSMF Scotsman Nugget Ice on Freestyle Kit - 17-3477-01 Operating instructions

Scotsman
Brand
Scotsman
Model
Nugget Ice & Dispenser Kit KFSMF Scotsman Nugget Ice on Freestyle Kit - 17-3477-01
Type
Operating instructions

Scotsman Nugget Ice & Dispenser Kit KFSMF Scotsman Nugget Ice on Freestyle Kit - 17-3477-01 helps make nugget ice and dispense it easily. It comes with an ice deflector that aids in dispensing, and a right side bin filler panel to avoid bridging. The ice dispensing rate can be adjusted to fill a 48 ounce cup in 8 seconds, and the agitation time can be set to 1 second on every 2 hours. To install the ice deflector, you need to loosen but not remove 4 screws that hold the ice chute to the bin, push the gate open, and slide the ice deflector from the kit between the bin and the ice chute.

Scotsman Nugget Ice & Dispenser Kit KFSMF Scotsman Nugget Ice on Freestyle Kit - 17-3477-01 helps make nugget ice and dispense it easily. It comes with an ice deflector that aids in dispensing, and a right side bin filler panel to avoid bridging. The ice dispensing rate can be adjusted to fill a 48 ounce cup in 8 seconds, and the agitation time can be set to 1 second on every 2 hours. To install the ice deflector, you need to loosen but not remove 4 screws that hold the ice chute to the bin, push the gate open, and slide the ice deflector from the kit between the bin and the ice chute.

Instructions
KFSMF Scotsman Nugget Ice on Freestyle Kit
Kit items and purpose:
• Installrightsidebinllerpaneltoavoidbridging.
• Installicedeectorinchute/gatetoaidindispensing.
Overall Steps
1. Installicedeector.
2. Installtherightsidebinllerpanel.
3. Adjusttheicedispensingrate.
4. Adjusttheagitationtime.
Helpful Tools:
• Stubbyphillipsscrewdriverforsolenoidscrews
• Longphillipsscrewdriver(18inch)forchutescrews
Ice Deector
1. Disconnectelectricalpower.
2. OpenFreestylefrontpanel/door.
3. Loosenbutdonotremove4screwsthatholdtheicechutetothebin.Tip:Usethelongscrew-
driverandbackthescrewsoutabout3turns.
4. Pushgateopenandfrominsidethebinslideicedeectorfromkit
betweenthebinandtheicechute.
5. Movethedeectorupanddowntoalignslotsindeectorwithpinson
icechuteandslipintoplace.Whenproperlypositioneditdoesnotmove
upanddowninthechute.Besuregatemovesfreelywhendone.
6. Tightenthe4screwstosecurethedeectorinplace.
Ice Deector
Loosen Screws
Install Deector
in Chute
17-3477-01
Right Side Bin Panel
7. Removebincover.
8. Locatefastenerlocationsonrightside.
9. Installllerpanelfromkitinsideright
sideofbin.Slipbottomangeof
panelbetweenplasticbottomandbin
wall.
10.Placechannelontopofrightsidebin
wallandtopedgeofllerpanel.
11.Secure channel to right side using
providedfasteners.
Insert right side
panel ange here.
Fastener Location Fastener Location in Channel
Right Side Panel
Channel
Adjust the ice dispense rate.
1. Reconnectelectricalpower.
2. Binmustbehalffullofnuggeticeand
hasbeentherefor2hours.
3. Dispense1vegallonbucketofice
beforemakinganyadjustments.
4. Usea48ouncecuptosetthedispense
speed,mustllthecupin8seconds.
Toadjust,loosenthe4solenoidmounting
screwsandslidethesolenoidupto
increasetherate,lowertodecrease.
Agitation time.
1. Setagitationtimeto1secondonevery
2hours.
2. Closethedispenserfrontpanel.
Loosen Screws
to allow moving
solenoid in slots
  • Page 1 1
  • Page 2 2
  • Page 3 3

Scotsman Nugget Ice & Dispenser Kit KFSMF Scotsman Nugget Ice on Freestyle Kit - 17-3477-01 Operating instructions

Scotsman
Brand
Scotsman
Model
Nugget Ice & Dispenser Kit KFSMF Scotsman Nugget Ice on Freestyle Kit - 17-3477-01
Type
Operating instructions

Scotsman Nugget Ice & Dispenser Kit KFSMF Scotsman Nugget Ice on Freestyle Kit - 17-3477-01 helps make nugget ice and dispense it easily. It comes with an ice deflector that aids in dispensing, and a right side bin filler panel to avoid bridging. The ice dispensing rate can be adjusted to fill a 48 ounce cup in 8 seconds, and the agitation time can be set to 1 second on every 2 hours. To install the ice deflector, you need to loosen but not remove 4 screws that hold the ice chute to the bin, push the gate open, and slide the ice deflector from the kit between the bin and the ice chute.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents