Vivanco FSS 31000W Owner's manual

Vivanco
Brand
Vivanco
Model
FSS 31000W
Category
Surge protectors
Type
Owner's manual

This manual is also suitable for

Page
Seite
D Bedienungsanleitung 4
GB Operating instructions 5
F Mode d’emploi 6
E Manual de Instrucciones 7
I Istruzioni per l’uso 8
NL Gebruiksaanwijzing 9
PL Instrukcja obsługi 10
P Manual de instruções 11
DK Betjeningsvejledning 12
S Bruksanvisning 13
FIN Käyttöohjeet 14
RUS
Руководство по эксплуатации
15
GR
Εγχειρίδιο οδηγιών χρήσης
16
TR Kullanım talimatı 17
CZ Návod k obsluze 18
SK Použitie 19
H Használati útmutató
20
FSS 31000W
Manual 26551:Layout 1 22.04.2009 10:11 Uhr Seite 1
Vivanco GmbH
Ewige Weide 15
D-22926 Ahrensburg/Germany
Fax +49(0)41 02 / 231 - 160
www.vivanco.com
Manual 26551:Layout 1 22.04.2009 10:11 Uhr Seite 2
1
2
3
4
5
6
7
8
9
10
Manual 26551:Layout 1 22.04.2009 10:11 Uhr Seite 3
Page is loading ...
5
GB Instruction Manual
Thank you for purchasing the wireless switch set FSS 31000W.
Before using the device please read the following instructions carefully in order to protect youself and
to avoid damages caused to your device.
1
. Mode of Operation
This set comprises 1 wireless remote control (1) and 3 wireless power outlet receivers (3). To be able to switch devices
by use of this wireless switch set, please proceed as follows:
1. Please take your wireless remote control (1) and open the cap (6) of the battery compartment (5).
2. Switch one or more of the DIP switches (4) 1 to 5 into “ON” position to adjust the house code.
3
. Take one wireless power outlet receiver (9) and open the flap (10) on the backside by use of a screw driver.
4. Now, please adjust the same house code as used with your wireless remote control.
5. The device code of the respective wireless power outlet receiver (9) is adjusted by use of the DIP switches A to D,
which comply with A to D on the remote control (1). Switch one of the 4 switches to “ON”.
6
. Now, close the flap (10) on the backside of the receiver (9).
7. Put the receiver (9) into the power outlet.
8
. Put your lamp into the power outlet of the receiver (7).
9. Repeat the process 3 – 8 for all further receivers (9) you would like to use. Please mind that the device code
(DIP A to D) must be different for each receiver (9).
10. Now, the FSS 31000W is ready for use.
2. Safety Instructions
- The maximum switching capacity of 1000 Watt per outlet must not be exceeded.
- For use in approved power outlets only. Do not use the device with extension cords.
-
Never use more than one receiver in a row.
-
Do not connect devices which could inflame other objects or cause any other damages if switched on unsupervised
(e.g. electric iron).
- Do not put needles or any other metal objects into the mains socket.
- Avoid humidity, extreme temperatures, vibrations and shocks.
-
To be used in protected rooms only, not for outdoor use.
-
Ambient temperature 0°C to 35°C must not be exceeded or fallen short of.
- Do not open the device. Repairs are only to be carried out by specialists only. If inappropriately installed, there is risk
of electric shock, short-circuit or fire.
- Only clean the FSS 31000W with a soft, slightly wet cloth. Do not use any scrubbing agents and solvents, do not
submerge. Dry before reusing the device.
- The FSS 31000W must not be used for devices with motor capacitor such as refrigerators etc.
- Please dispose old batteries in an environmentally friendly way.
3. Troubleshooting
If the FSS 31000W should not function properly, please check the following:
Pilot lamp in the hand transmitter does - Check if battery correctly inserted (polarisation).
not light when pressing a device button - Check if contact between battery and clamps is faultless, if necessary
press against it.
- Check battery condition and renew if necessary.
Transmission control lights up, - Check if load is switched on.
no reaction with loads - Check if device code of receiver complies with the button pressed.
gedrückten Taste übereinstimmt.
- Approach and check if operating distance is sufficient for desired
location.
Distance to low - For long distances ensure that operating field is free of obstacles.
- If the distance is only temporarily restricted this might be caused
by another transmittor which is simultaneously operated with a
similar frequency (e.g. wireless headphones, speakers, etc.).
4. Warranty
Manufacturer warranty for this product is limited to 2 years and to material and accuracy of processing only. Repairs
under warranty may only be performed by authorised service departments. The original receipt must be included as proof
of purchase. Excluded by this warranty are normal wear, modifications, revisions, damages due to inadvertance and/or
inappropriate use, third-party influence, application fields the product is not designed for or completely or partially
disassembled products.
5. Technical Data Coverage: up to 25m
Battery: 12Volt, alkaline, type CN23A, EL12,
VR22 or MN21
Transmission frequency: 433.92MHz
Wireless power outlet receiver Mains voltage: 230V~, 4,35A, 1000W
Switching capacity: max.1000W
Power consumption: < 5 W
Manual 26551:Layout 1 22.04.2009 10:11 Uhr Seite 5
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20

Vivanco FSS 31000W Owner's manual

Vivanco
Brand
Vivanco
Model
FSS 31000W
Category
Surge protectors
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents