Furrion WF8023 Wireless Module User manual

Product:2.4GHzwirelessmoduleModel(s):WF8023

OEM/IntegratorsInstallationsUserManual

Note:ThemoduleislimitedtoOEMinstallationONLY;

TheOEMintegratorisresponsibleforensuringthattheend‐userhasnomanualinstructionsto

removeorinstallmodule.

IftheFCCidentificationnumberisnotvisiblewhenthemoduleisinstalledinsideanotherdevice,then

theoutsideofthedeviceintowhichthemoduleisinstalledmustalsodisplayalabelreferringtothe

enclosedmodule.

Thisexteriorlabelcanusewordingsuchasthefollowing:

“ContainsTransmitterModuleFCCID:2ABH3-FOSFDTA”

Whenthemoduleisinstalledinsideanotherdevice,theusermanualofthisdevicemustcontain

belowwarningstatement:

1、ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothefollowingtwo

conditions:

(1)Thisdevicemaynotcauseharmfulinterference.

(2)Thisdevicemustacceptanyinterferencereceived,includinginterferencethatmaycauseundesired

operation.

2、AnyChangesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliance

couldvoidtheuser'sauthoritytooperatetheequipment.

Note:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,

pursuanttopart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotection

againstharmfulinterferenceinaresidentialinstallation.Thisequipmentgenerate,usesandcan

radiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththeinstructions,may

causeharmfulinterferencetoradiocommunications.However,thereisnoguaranteethatinterference

willnotoccurinaparticularinstallation.Ifthisequipmentdoescauseharmfulinterferencetoradioor

televisionreception,whichcanbedeterminedbyturningtheequipmentoffandon,theuseris

encouragedtotrytocorrecttheinterferencebyoneormoreofthefollowingmeasures:—Reorientor

relocatethereceivingantenna.

— Increasetheseparationbetweentheequipmentandreceiver.

— Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiveris

connected.

— Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

Note:TheGranteeisnotresponsibleforanychangesormodificationsnotexpresslyapprovedby

thepartyresponsibleforcompliance.Suchmodificationscouldvoidtheuser'sauthorityto

operatetheequipment.

Thatseparateapprovalisrequiredforallotheroperatingconfigurations,includingportable

configurationswithrespecttoPart2.1093anddifferentantennaconfigurations.

ThisproductismountedinsideoftheendproductonlybyprofessionalinstallersOEM.Theyusethis

modulewithchangingthepowerandcontrolsignalsettingbysoftwareofendproductwithinthe

scopeofthisapplication.Endusercannotchangethissetting.

TheequipmentcomplieswithRFexposurelimits.Thismoduleislimitedtoinstallationinmobileor

fixedapplications.Theantennausedforthistransmittermustnotbeco‐locatedoroperatingin

conjunctionwithanyotherantennaortransmitter.

ThedevicehasbeenevaluatedtomeetgeneralRFexposurerequirement.

TomaintaincompliancewithFCC'sRFexposureguidelines,thisequipmentshouldbeinstalledand

operatedwithaminimumdistanceof20cmbetweentheradiatorandyourbody.

IftheICidentificationnumberisnotvisiblewhenthemoduleisinstalledinsideanotherdevice,then

theoutsideofthedeviceintowhichthemoduleis

installedmustalsodisplayalabelreferringtotheenclosedmodule.Thisexteriorlabelcanuse

wordingsuchasthefollowing:

“ContainsTransmitterModuleIC:23337-FOSFDTA”

Whenthemoduleisinstalledinsideanotherdevice,theusermanualofthisdevicemustcontain

belowwarningstatements:

ThisdevicecomplieswithIndustryCanadalicense‐exemptRSSstandard(s).Operationissubjecttothe

followingtwoconditions:(1)thisdevicemaynotcauseinterference,and(2)thisdevicemustaccept

anyinterference,includinginterferencethatmaycauseundesiredoperationofthedevice.

LeprésentappareilestconformeauxCNRd'IndustrieCanadaapplicablesauxappareilsradioexempts

delicence.L'exploitationestautoriséeauxdeuxconditionssuivantes:(1)l'appareilnedoitpas

produiredebrouillage,et(2)l'utilisateurdel'appareildoitacceptertoutbrouillageradioélectriquesubi,

mêmesilebrouillageestsusceptibled'encompromettrelefonctionnement.

Setup

Installation:

1. Connect 3.3V regulate power to the Module 3.3V pin.

2. Connect GDN to Module GND.

3. Connect Enable pin to Module REST pin.

4. Connect Host USB Interface DP/DM to module DP/DM

5. Connect antenna to Module RFA or RFB pin.

Note:

One side of a coaxial cable (RG178) is connected to the antenna pin of the module, and the

other side is connected to the antenna through the RP-SMA connector. The length of coaxial

cable is 0.18m.

Antenna Specification

Frequency Range(MHz)

2.4GHz~2.5GHz

Impedance(Ω)

Peak Gain(dBi)

3.0dBi

VSWR

≤1.8

Admitted Power

50W

Polarization

Linear, Vertical

Radiation

Omni-directional

Connector

RP-SMA

More module information is provided below:

WF8023 BOTVIEW

WF8023 TOPVIEW

Pin Assignment

Pin NO.

Pin Name

Pin Description

I/O

RST

Connect to 3.3V via a 100k

resistor

2，6，

8，10

GND

Ground

USB Interface DP

I/O

USB Interface DM

I/O

3.3V

Power Supply

RFA

Connect to antenna

I/O

RFB

Connect to antenna

I/O

Outline Dimension

Furrion WF8023 Wireless Module User manual

Other documents