SETTING THE UNIDOCK TO THE SIZE OF THE DEVICE
The guides of the unit need to be adjusted to align the connectors for a complete connection.
The row of blue plastic guides should be adjusted for the devices you will use. Power off and disconnect the power cord before
proceeding
Step 1. Step 2. Step 3.
Step 4. Step 5.
Use the provided T-handle Allen
wrench to remove the four screws
from the top cover of the UniDock.
Set the screws and cover aside in a
safe place.
Loosen each of the socket screws on the
ends of the guide assemblies (1/2 turn of
the Allen key is enough to loosen the
screws). Slide the guides to the widest
position and snug the screws to hold the
guides open.
Plug/connect two of your mobile devices,
one to the front and one to the rear of
the guides. Place both devices facing
forward (as shown). This is to establish
your device’s spacing (width).
Loosen the front and back screws (1/4 to ½ turn) on one guide
assembly. It should snap inward. Loosen the screws for the
second guide assembly in the same manner. The guides are
“sprung” to help center and position the guides in relation to
the connectors on the base. Use the Allen key to tighten the
two front and rear socket screws.
The device should center in the V groove when properly positioned.
Connect the remaining devices in the row and check
that each one slides in and out freely as well as
connects securely and with little effort. Repeat the
adjustment process if the devices are not consistently
docking easily.
Repeat steps 1-5 for the second row of devices.
Reinstall the top cover and replace the four screws, using the Allen key. Reattach the Allen key in its holder at the back of the UniDock.
-
1
Datamation UniDock-16-MICRO-USB Quick setup guide
- Type
- Quick setup guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Fusion MS-RA205 User manual
-
-
-
-
Grizzly G0668 User manual
-
SportsArt T655MD Owner's manual
-
Krone BA EasyCollect 450-2/ 600-2/ 750-2 Operating instructions
-
South bend SB1041 Owner's manual
-
Wilton 7060 User manual
-
