katranji DSO150 User manual

Type
User manual

The katranji DSO150 is a portable oscilloscope that can measure AC or DC voltage up to 5V, display waveforms on its LCD screen, and pause or adjust the signal for detailed analysis. It features two channels (CH1 and CH2) for simultaneous signal measurement and allows you to switch between single and dual-channel modes. The timebase can be set from 100 microseconds to 1 second, and the voltage level can be adjusted between 0 and 5.1V. The DSO150 is powered by a USB cable or an optional 3.7V lithium battery.

The katranji DSO150 is a portable oscilloscope that can measure AC or DC voltage up to 5V, display waveforms on its LCD screen, and pause or adjust the signal for detailed analysis. It features two channels (CH1 and CH2) for simultaneous signal measurement and allows you to switch between single and dual-channel modes. The timebase can be set from 100 microseconds to 1 second, and the voltage level can be adjusted between 0 and 5.1V. The DSO150 is powered by a USB cable or an optional 3.7V lithium battery.

DIY Oscillo DSO150
User Manual
Requirements:
USB Power Supply cable or Lithium Battery 3.7V (optional)
AC or DC Voltage 0 5V MAX or optional Signal Generator
Testing Probes
Instructions:
- Connect the probes cable in one of the following Channels (CH1 CH2)
- Connect the USB Power cable or use the Battery Switch to turn on the Oscilloscope
- Once the power is connected; LCD will turn on. Adjust the trimmer for LCD contrast at the rear
side by an isolated screw driver
- Choose the Number of testing Channels CH1 CH2 testing by turning Slide Switch (SW1) to left
- The tested signal can be paused by turning Slide Switch (SW1) to Right , the screen will
show the Single function in the right bottom corner and will pause the shown tested signal with
READY message, push (SW1) to show the next cycles of the signal, to get back to instant
testing signal turn the Slide Switch (SW1) Right , the screen will show the AUTO function and
review instant signal testing
- The signal cycle can be determined in Micro & Milli seconds by turning the Slide Switch SW2
rightand Left
Starting the following:
100 200 500 uS Micro seconds
1 CHANNEL 2 CHANNELS
1 2 5 10 20 50 100 200 500 - 1000 mS milliseconds
- Scroll Offset to adjust the signal X-Axis Offset
- Use the Level to adjust the signal input voltage between 0v to 5.1V
- Push the slide Switch SW2 to turn the testing signal between and +
DIY OSCILLO DSO150


USB



(CH1 CH2)
USB
- 
CH1 CH2 SW1
(SW1)  Single
READY,
(SW1) (SW1)
(SW1)AUTO
(SW2)


 

OFFSET
LEVEL
SW2
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

katranji DSO150 User manual

Type
User manual

The katranji DSO150 is a portable oscilloscope that can measure AC or DC voltage up to 5V, display waveforms on its LCD screen, and pause or adjust the signal for detailed analysis. It features two channels (CH1 and CH2) for simultaneous signal measurement and allows you to switch between single and dual-channel modes. The timebase can be set from 100 microseconds to 1 second, and the voltage level can be adjusted between 0 and 5.1V. The DSO150 is powered by a USB cable or an optional 3.7V lithium battery.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI