Assembly Instructions
INSTRUCTIONS
(1) Assembly three legs to the windshield of top frame with 6pcs bolts
and nuts.
(2) Assembly three legs to the bottom ring with 3pcs bolts and nuts.
(3) Assembly two adjustable side pot holders to the top frame with 4pcs
bolts and nuts.
(4) Unscrew the pre-assembled lock nut and flange nut from the
threaded pin of the cast iron burner，then insert the threaded pin of
burner through the hole of the support bar of top frame， wrench
tighten flange nut and lock nut.
*Make sure all hardware are used and wrench tighten.
TOOLS NEEDED FOR ASSEMBLY
•Adjustable Wrench
•Phillips screwdriver
Instructions
1. Place stove on a level, stable surface.
2. Attach propane hose to the brass stove inlet fitting.
3. Make sure propane bulk tank valve is closed.
4. Attach propane hose to outlet of propane tank.
5. Slowly open propane tank valve and check for leaks by applying
small amount of liquid soap and looking for bubbles to appear.
Note: When connecting the Hose to unit, insert
the male fitting of the hose. Tighten the fitting
onto the throat of the burner using a wrench.
Do not overtighten. You should be able to turn
the air control panel.
PREPARATION：
1. Read instruction before lighting.
2. When you are sure there are no leaks, turn cylinder valve and regulator control valve on hose to the closed position.
3. Have a fireplace match or long-nosed lighter lit and over the burner from SIDE. Keep hands and face away from burner.
4. Slowly open gas supply until burner ignites, keeping hands and face away from burner.
5. Adjust the regulator control valve for desired flame height.
6. When finished using the cooker, turn off gas cylinder valve first. lt will take a few secondfor the fire to go out and for the propane
gas to bleed from the hose and regulator assembly. After the fire is completely out, turn regulator control valve to the OFF position.
7. To re-light, repeat steps 1-6. Always use CAUTION as cooker will be hot.
8. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting procedure.
LIGHTING INSTRUCTIONS
CAUTION
DO NOT attempt to connect your camp stove to a natural gas supply. Use only
with propane, hose and regulator supplied with the stove and an approved bulk
propane tank.
STORAGE
1. DO NOT leave propane tank attached to stove during storage or transport.
2. Wipe the burners, steel cooking grate, and propane hose before storing.
3. It is suggested to store stove and hose in a nylon storage bag to keep it clean.
Cast iron burner
Top Frame
Adjustable side
pot holders
Legs
Bottom Ring
Counter clockwise to
open the gas supply
.61m
24''
Bolts/Nuts
