2. BCS
  3. 85.400.001

BCS 85.400.001 User manual

  • Hello, I've reviewed the service information regarding the BCS Pressure Washer and Soap Injector Kit. This document outlines the process for switching hose and pump fittings to allow for the installation of the Soap Injector Kit. I'm ready to answer your questions about the procedure.
  • What does the BCS Pressure Washer hose include?
    How is the Pressure Washer’s pump fitted?
    What is the purpose of exchanging the connectors?
3-16
SERVICE
INFORMATION
UPDATED 9/23/2020
SUBJECT:
SWITCHING HOSE AND PUMP FITTINGS IN ORDER TO INSTALL SOAP
INJECTOR KIT ON THE BCS PRESSURE WASHER.
The BCS Pressure Washer includes a hose that is tted
with one male and one female connector on each end. The
Pressure Washer’s pump is tted with a male connector
(see gure 1).
In order to install the Soap Injector Kit with the ow of water going in the correct direction
(gure 2), the female connector from the hose and the male connector from the pump need to
be exchanged (gure 3).
Once the two connectors are exchanged, the Soap Injector Kit can be installed between the
pump and the hose (gure 4).
If you have questions, please contact BCS America at 1-800-543-1040, or email [email protected]
Page 1 of 1
Fig. 1
Fig. 2
Fig. 4
Fig. 3
/