Vc1 key UI indicator Description
Easy Set Up
65x100mm
Setup code
VOCOlinc APP
Lens
Smart Indoor Camera
VC1
7
1Lightsensor
2
Infrared LED
3Microphone
4
Speaker
5Indicator lights Note: the device only supports the addition and use of
homekit platform under IOS system.
Please use 2.4G WiFi access point to configure the device.
The device does not support 5gwifi access point.
Please open the "home" app in the IOS system, select "+",
scan the setup code on the body or package as required,
and add the device.
After adding the device, you can see the device and image
preview in the home interface.
Click preview to enter the full screen state. You can set the
image preview configuration in the full screen state.
After entering the settings, you can set specific functions.
You can also search for "VOCOlnc" APP in the APP Store, and
add devices to the APP.
Press and hold the key
for 10 seconds
The blue light will flash slowly
Power on and not paired
(or WiFi is disconnected)
The device is reset, the red and
blue lights flash alternately,
and the horn gives a short
sound
Warm note:
Please make sure your router is connected to Internet.
6
Reset button
Step1 Add accessory
Step2 Using and configuring accessory
Due to the limitation of homekit platform, if the device needs
to upgrade OTA or control the pan tilt rotation, it needs to be
controlled through the vocolinc app.
Step3 Accessory OTA and pan&tilt control
7Power port
8
8
Safety Warnings
FCC Declaration
• For indoor use only
• Unplug from VC1 before cleaning
• DO NOT clean with liquid
• DO NOT use in wet or damp areas
• Keep children away from VC1
• DO NOT use the device when the casing is broken
Caution:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation. Any Changes or modifications not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
The antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or
transmitter.
Caution:
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) This device must
accept any interference, including interference that may cause undesired
operation of the device. In order to avoid the possibility of exceeding
the ISEDC radio frequency exposure limits, human proximity to the
antenna shall not be less than 20cm (8 inches) during normal operation.
IC Declaration
Short press of key No function
Blue light is always on
WiFi configuration is
successful (start to allow data
stream and recording)
WiFi configuration is
successful (turn off allow data
stream and recording)
All lights are off
Homekit paired successfully Blue light flashes 5 times
Upgrade Blue flash
In video recording (real-time
data stream or recording) Red light is always on
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
L’appareil ne doit pas produire de brouillage;
L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Déclaration d'exposition RF:
L'équipement est conforme à la limite d'exposition aux radiations
de la IC établie pour un environnement non contr?lé. Cet équipement
doit être installé et utilisé avec une distance minimale de 20 cm
entre le radiateur et votre corps.
1
Pyle PPHP652B User manual
Huion Kamvas Studio 24 User guide
Xiaomi центр умного дома (ZHWG11LM) User manual
Aqara центр умного дома (ZHWG11LM) User manual
Kono KN-S-AMZ-004 User manual
Insignia NS-SP1XM8 | NS-SP1XM8-C Quick setup guide
Legrand HKMS2 Installation guide
Crestron MC4-R-I Product information
iDevices Wall Outlet User manual
