Olimpia Splendid Caldostile F User manual

Brand: Olimpia Splendid

Model: Caldostile F

Category: Space heaters

Type: User manual

Olimpia Splendid Caldostile F is a safe and versatile ceramic fan heater with two heat settings (1000W/2000W), fan-only mode, and an adjustable thermostat. It features a 12-hour timer and oscillation function for even heat distribution. Safety features include tip-over and overheat protection. The device is suitable for well-insulated spaces or occasional use.

Caldostile F

INSTRUCTIONS FOR INSTALLATION, USE AND MAINTENANCE THIS PRODUCT

IS ONLY SUITABLE FOR WELL INSULATED SPACES OR OCCASIONAL USE

SAFETY

Read the Installation and User Guide(*), especially the safety instructions below.

WARNING -Certain parts of this product

may become very hot and may cause

burns. Pay extra attention to small

children and vulnerable people when

they are around the heater.

This heater may be used by children aged 8 and over and by persons with

reduced physical, sensory or mental capacity or without any experience or

knowledge providing they are correctly supervised, or they have been given

instructions on how to use the heater safely and they clearly understand the

potential hazards. Children must not play with the heater unless supervised.

Children must not perform user cleaning and maintenance.

Ensure children aged under 3 are kept at a safe distance unless they are

under constant supervision.

Children aged between 3 and 8 may only turn the heater on or off providing it

has been placed or installed in the normal position for its operation and

providing they are under supervision, or they have been given instructions on

how to use the heater safely and clearly understand the potential hazards.

Children aged between 3 and 8 must not plug in, change the heater

settings, clean or perform any user maintenance on the heater.

Do not insert anything into the heater.

The heater may only be connected by a qualified person after the power has

been switched off.

Caution,

hot surface

GENERAL INFORMATION

We wish to thank you for purchasing a heater produced by our company. This document

is restricted in use to the terms of the law and may not be copied or transferred to third

parties without the express authorisation of the manufacturer.

Our heaters are subject to change and some parts may appear different from the ones

shown here, without this affecting the text of the manual in any way.

Read this manual carefully before performing any operation (installation, maintenance,

use) and follow the instructions contained in each chapter. Keep the manual carefully for

future reference. After removing the packaging, check that the appliance is in perfect

condition. The packaging materials must not be left within reach of children as they can

be dangerous.

THE MANUFACTURER IS NOT RESPONSIBLE FOR DAMAGES TO PERSONS OR

PROPERTY CAUSED BY FAILURE TO FOLLOW THE INSTRUCTIONS IN THIS

MANUAL.

The manufacturer reserves the right to make any changes it deems advisable to its

models, although the essential features described in this manual remain the same.

During installation and maintenance, respect the precautions indicated in the manual,

and on the labels applied inside the units, as well as all the precautions suggested by

good sense and by the safety regulations in effect in your country.

This product is covered by a 2-year warranty

For more information please contact:

AUSTRALIA:

email: sales@olimpiasplendid.com.au, PH +61 (03) 9563 2778

www.olimpiasplendid.com.au

NEW ZEALAND:

email: admin@keyserviceltd.co.nz, PH +64 (09) 916 0960

www.olimpiasplendid.co.nz

IMPORTANT SAFETY INFORMATION

1. Avoid installation behind a door.

2. Use only the voltage specified on the rating plate of the heater.

3. Do not cover or restrict airflow to the inlet or exhaust grilles in any manner as the

appliance may overheat and become a fire risk (for Fan Heaters).

4. Do not cover grilles, block entry or exhaust of airflow by placing appliance against

any surface. Keep all objects at least 1-metre from the front and sides of the

appliance. With the exception of appliances designed for wall-mounting, maintain

a 1 metre gap from the rear of the unit as well.

WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR

POSITIONED CLOSE TO CURTAINS OR OTHER COMBUSTIBLE

MATERIALS

5. Do not place appliance close to a radiant heat source.

6. Do not operate in areas where gasoline, paint or other flammable liquids are used

or stored.

7. This appliance heats up when in use. To avoid burns, do not let bare skin touch

hot surfaces. Switch off and use handles where provided when moving.

8. Do not use the appliance to dry clothes.

9. Do not leave the appliance unattended whilst in use.

10. Do not insert or allow foreign objects enter any ventilation or exhaust opening, as

this may cause an electric shock, fire or damage to the appliance.

11. Do not immerse in liquid or allow liquid to run into the interior of the appliance, as

this could create an electrical shock hazard.

12. Do not use this appliance on a wet surface, or where it can fall or be pushed into

water.

13. Do not reach for an appliance that has fallen into water. Switch off at supply and

unplug immediately.

14. Do not operate any appliance with a damaged cord, plug or after the appliance

malfunction or has been dropped or damaged in any manner. Return to a

qualified electrical person for examination, electrical or mechanical adjustment,

service or repair before further use.

15. Do not operate appliance with wet hands.

16. This appliance is intended for household use only and not for commercial or

industrial use.

17. Use this appliance only as described in this manual. Any other use is not

recommended by the manufacturer and may cause fire, electric shock or injury.

18. A common cause of overheating is deposits of dust or fluff in the appliance.

Ensure these deposits are removed regularly by unplugging the appliance and

vacuum-cleaning air vents and grilles, where available.

19. Do not use this appliance in a window as rain may cause electric shock.

20. Do not use abrasive cleaning products on this appliance. Clean with a damp cloth

(not wet) rinsed in hot soapy water only. Always unplug the unit before cleaning.

21. Do not connect the appliance to the mains source until it has been installed in its

final location and adjusted to the position it will be used in.

22. This appliance is not intended for use in bathrooms, laundry or similar locations

which may be exposed to water, moisture or humidity.

23. Always operate on a flat horizontal surface.

24. Switch off the appliance, then use handles (where provided) to change its

position.

25. Do not operate with the cord coiled up as this could cause a build up of heat,

which could pose a hazard.

26. Do not use an extension cord or power board with the appliance.

27. Do not remove the power plug from the socket by pulling the cord – grip the plug

instead.

28. Always unplug appliance when not in use.

29. Do not allow cord to come in contact with heated surfaces during operation.

30. Do not run cord under carpeting, throw rugs or runners etc. Arrange cord away

from areas where it is likely to be tripped over.

31. Do not twist, kink or wrap the cord around the appliance, as this may cause the

insulation to weaken and split. Always ensure that the cord has been fully

removed from any cord storage area before use.

32. Do not store appliance in a box or closed space until it has cooled down

sufficiently.

33. This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

34. Young children should be supervised to ensure they do not play with the

appliance.

35. The appliance must not be located immediately below a socket-outlet.

36. Do not use this appliance with a programmer, timer or any other device that

switches the heater on automatically, since a fire risk exists if the appliance is

covered or positioned incorrectly.

37. If the supply cord is damaged, it must be replaced by a qualified electrical person

in order to avoid a hazard.

38. Do not use this appliance outdoors, or on wet surfaces. Avoid spilling liquid on

the appliance.

39. In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this

appliance must not be supplied through an external switching device, such as a

timer, or connected to a circuit that is regularly switched on and off by the utility.

40. For additional protection, the use of a Residual Current Device (RCD) with a

tripping current not exceeding 30mA is recommended.

Warning: Very hot surface Important: Do not cover

OVERVIEW

OPERATION

1. Before inserting the plug into an electrical outlet, make sure that the electrical

supply in your area matches that on the rating label on the unit.

2. When plugged in, turn on the Main power switch at the rear of the unit.

3. When in Standby mode, only ON/OFF on the control panel will respond to your

touch. Press ON/OFF to access the rest of the control panel.

CONTROL PANEL

a) Press switch to fan function, press again and the heater will turn off

automatically in 30 seconds.

b) Press to switch the power on. Press to switch to low power, press it again,

for high power, press it third time, to change to fan function.

c) Press again, the heater will turn off automatically in 30 seconds

d) TIMER: Press repeatedly to set a period after which the heater will turn itself

off (between 1 hour - 12 hours, in steps of 1 hour). During timer operation, the

remaining operating time is displayed, until the heater turns itself off. Pressing

the timer button once more after the display shows 00 hours will cancel the timer.

e) OSC: Press to activate oscillation. Press again to cancel.

f) While using, press ‘+’& ‘-‘ to control the temperature. When the room temperature

rises to the set temperature, the heater will stop heating. When room temperature

drops below set temperature, the heat will turn on again.

g) Regulate the temperature by pressing ‘+’ ‘-‘. Start-up again, first time press ‘+’ ‘-‘, the

temperature starts from room temperature (then change according to last

temperature setting), keeping between 35℃ and 10℃. Each press changes by 1℃.

Pressing ‘+’ & ‘-‘, on the display will show the desired temperature setting, after

which the display will show the current room temperature.

h) Movable head (forward/backward): Set the unit to the desired angle to project the

heat. See below photo.

Warning: The heater will remain hot for some time after it is turned off; handle with care.

Remote control

Please use Lithium battery CR2025 3V.

NOTE: the remote control buttons perform the same functions as those on the control

panel on the unit.

TIP-OVER PROTECTION

This heater is protected with a safety switch that turns off the appliance automatically

when the heater falls over or is at an excessive angle (horizontal). This helps prevent

accidents, and the heater will resume operation when it is put back upright.

If it is suspected the battery has

been swallowed or otherwise

placed inside any part of the

body, a person should contact

the Australian Poisons

Information Centre immediately

on 13 11 26 (in Australia) or

0800 764 766 (in New Zealand)

for fast, expert advice.

THERMAL CUT-OFF

This heater is protected with thermal cut-off protection that switches off the appliance

automatically in case of severe overheating. In this case, unplug the appliance, wait

about 30 minutes for it to cool and remove any possible cause of overheating, eg.

something covering the heater. Check for damage to the appliance, the cord and the

plug. If there is no damage, plug the unit back in and switch it on as described above. If

the heater still does not turn on, please contact Customer Service for assistance.

CLEANING & MAINTENANCE

•Before undertaking any cleaning or maintenance on the appliance, disconnect it

from the power supply.

•For cleaning it is recommended to use a soft moist rag and neutral detergent. Do

not use an abrasive cloth or devices which could affect the appearance of the

appliance. Check that the hot air outlet and the ventilation inlet are free of dust

and dirt. During cleaning, be careful not to touch the heating elements.

•In case of breakdown and/or poor functioning of the appliance, disconnect the

appliance from the power supply and contact an authorised repairer.

SPECIFICATIONS

Power Supply: AC 220-240V ~ 50Hz

Power Consumption: 2000W

Environment

Meaning of crossed-out wheeled dustbin:

Do not dispose of electrical appliances as unsorted municipal waste, use

separate collection facilities. Contact your local council for information

regarding the collection systems available. If electrical appliances are

disposed of in landfills or dumps, hazardous substances can leak into the

groundwater and get into the food chain, damaging your health and well-being.

Olimpia Splendid Caldostile F User manual

Brand: Olimpia Splendid

Model: Caldostile F

Category: Space heaters

Type: User manual

Download PDF

report

Olimpia Splendid Caldostile F User manual

Olimpia Splendid Caldostile F User manual

Other documents