Aqua Science Fleck 5600 Easy Programming Manual

Type
Easy Programming Manual
Est. 1985
800-767-8731
www.aquascience.net
Fleck 5600 & 2510 12 Day Timer
Easy Programming Guide
2
www.aquascience.net800-767-8731
Fleck 5600 & 2510 12 Day Timer Easy Programming Guide
Setting Time of Day:
Press red button and rotate largest spin wheel (with serrated edges) until the current time is displayed
in the “time of day” window.
3
www.aquascience.net800-767-8731
Fleck 5600 & 2510 12 Day Timer Easy Programming Guide
Setting Backwash Frequency:
The 12 day timer comes with all 12 pins pushed inward.
To indicate the days you want to backwash, simply push that particular pin outward from the center.
The industry standard is for every 3 days. That will result in the 1,4,7 and 10 pins being pushed out.
The red arrow indicates what day you are currently on in that 12 day cycle.
4
www.aquascience.net800-767-8731
Fleck 5600 & 2510 12 Day Timer Easy Programming Guide
Final Steps:
Once your control valve is set to run, clip the stainless steel bypass to the inlet/outlet.
Next, turn the central dial clockwise into backwash and slightly turn the bypass valve into service. After
a few minutes you can fully open the bypass valve into service.
This helps maintain a controlled ow of water into your media tank. Once your tank is fully saturated,
turn the central dial back to in service.
If you have any questions, feel free to give Aqua Science a call at 800-767-8731 or send us an email
through our website at www.aquascience.net.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Aqua Science Fleck 5600 Easy Programming Manual

Type
Easy Programming Manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI