5019 312 00032
Whirlpool is a registered trademark of Whirlpool USA.
N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.
Programme
Care
Labels
Type of wash / Notes
Max.
load
kg
Detergents and additives Special Options Tempera-
ture
°C
Max.
Spin
Speed
rpm
Prewash Main
Wash
Softener Bleach Rapid Intensive
Rinse
Rinse
Hold
Cotton with prewash
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
5.0
Yes
1)
Yes
❉❉❉❉❉
Max. 90 700
Synthetic with prewash
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or
blends with cotton.
2.0
Yes
1)
Yes
❉
—
❉❉❉
Max. 60
700
2)
Delicate with prewash
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
1.5
Yes
1)
Yes
❉
—— —
❉
Max. 40
700
2)
Cotton
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
5.0
—
Yes
❉❉❉❉❉
Max. 90 700
Coloured
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and
linen.
3.0
—
Yes
❉
——
❉❉
Max. 60 700
Mixed synthetics/
Cotton
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
2.0
—
Yes
❉
—
❉❉❉
Max. 60
700
2)
Synthetic Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.
1.5
—
Yes
❉
——
❉❉
Max. 60
700
2)
Delicate
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
1.5
—
Yes
❉
—— —
❉
Max. 40
700
2)
Wool
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
1.0
—
Yes
❉
—— —
❉
Max. 40
700
2)
Silk
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
1.0
—
Yes
❉
—— —
❉
Max. 30
—
3)
Rinse + Gentle Spin
+
Same as the last two rinses and the final spin in the "Synthetic" programme. P
rogramme for treating wash
with starch or softener.
2.0
——
❉
—— —
❉
—
700
2)
Rinse + Spin
+
Same as the last rinse and the final spin in the “Cotton” programme.
Programme for treating wash with starch or softener.
5.0
——
❉
—— —
❉
—
700
Spin
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
5.0
————— —— —
700
Gentle spin
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
2.0
————— —— —
700
2)
Drain
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
———— —— —— — —
A. Temperature Selection Knob
B. “Programme Sequence” Indication
C. “On/Off” Button
D. “Spin Speed Selection” Knob
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted to
700 rpm in this programme.
3)
For improved garment care, spin speed is zero in this
programme.
“Cold”
“No spin”
ABDC
AWT 5078
GB
5019 312 00032
Whirlpool is a registered trademark of Whirlpool USA.
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
1. Load the machine, close the drum flaps and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
“MAX“
level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
desired temperature.
5. Turn the
spin speed selector knob
to the desired
spin speed. If the spin speed “” is selected, the
final spin is cancelled, but not the intermediate
spins. The programme ends with a drain cycle.
Selecting or deselecting an option can be done at
any time during the programme. The option will
be applied as long as the corresponding
programme phase has not been executed yet.
“Rapid” button
• For fast, energy saving wash cycles.
• Ideally suited for small loads consisting of lightly
soiled laundry.
“Intensive Rinse” button
• One rinse cycle is added to ensure a more
intensive rinse.
• This option is particularly suitable for areas with
very soft water, washing baby linen and people
with detergents allergies.
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5.0 63* 1.80 2:05
Cotton 60 5.0 55 0.95 2:05
Cotton 40 5.0 55 0.55 2:05
Synthetic 60 2.0 56 0.80 1:35
Synthetic 40 2.0 50 0.40 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
PREPARATION OF WASH CYCLE
SELECT THE DESIRED OPTION
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic” or “Delicate” programmes.
• This function is particularly useful if you want
to postpone spinning to a later time, or if you
want to drain only.
Remark:
the programme selector knob stop on ““.
Appliance in “Rinse Hold”:
• Press again the “Rinse Hold” button : the
programme will terminate automatically with
the selected spin cycle.
• If you do not wish to spin the clothes, press
the “
On/Off
” button , turn the programme
selector knob to the “Drain” programme
and press the “
On/Off
” button again.
Turn on the tap and press the “
On/Off
” button .
The indicator light of the “
On/Off
” button
lights up.
Remark
: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it was
interrupted.
• The programme selector knob is in the Stop
position “”.
1. Press the “
On/Off
” button to switch off
the machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the door to unlock (about 1 minute).
5.
Open the door and the drum flaps and unload
the machine.
1. Switch off the machine by pressing the “
On/
Off
” button .
2. Select the new programme.
3.
Start programme by pressing the “
On/Off
”
button again.
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the “
On/Off
” button .
2. After the desired pause, press again the
“On/
Off”
button .
1. Switch off the machine by pressing the “
On/
Off
” button .
2. Set the programme selector to “Drain” .
3. Press the “
On/Off
” button again to start
the “Drain” programme .
PROGRAMME START
END OF WASH CYCLE
CHANGE THE PROGRAMME DURING THE WASH
CYCLE
PAUSE/INTERRUPT A PROGRAMME
CANCEL PROGRAMME
/