Notice:
This bulletin replaces bulletin 2009009298.1. This update has
been issued to communicate some new information regarding
the issue.
BULLETIN ID: 2009009298, Rev 2
PUBLISHED: 2009-07-02
STATUS: Active
REGION: APAC
CALA
EMEA
GC
NA
PRIORITY: Information
TYPE: Bulletin
Reissue Reason:
1) UNIStim 3.1 now installed in the factory
2) Support for IP Phone 1120E and 1140E new hardware revision
3) Product advisements with Algo 4900 USB ATA
Background:
Nortel is pleased to announce the availability of UNIStim firmware release 3.1 for IP Phones. UNIStim firmware release
3.1 makes available firmware versions:
- 0604DCG for Phase II IP Phone 2001, Phase II IP Phone 2002 and Phase II IP Phone 2004
- 0621C6H for IP Phone 2007
- 0623C6J, 0624C6J, 0625C6J and 0627C6J for IP Phone 1110, IP Phone 1120E, IP Phone 1140E and IP Phone 1150E
respectively
- 062AC6J for IP Phone 1210, IP Phone 1220 and IP Phone 1230
Nortel recommends an upgrade to these releases of firmware for all applicable IP Phones and Call Servers at the earliest
convenience. These releases are being provided as a no charge update to all customers.
UNIStim firmware release 3.1 for IP Phones is available for download from the Software Download link under Support and
Training on the Nortel website located at http://support.nortel.com. The firmware is available by phone model under
Phones, Clients and Accessories.
The respective firmware loads have also been introduced as the default loads shipped from Nortel for the Phase II IP
Phone 2004 and 2002 (but not the Phase II IP Phone 2001), IP Phone 2007, IP Phone 1110, 1120E and 1140E (but not
the IP Phone 1150E). Also, note that the IP Phone 1210, 1220 and 1230 do not contain default firmware loads shipped
from Nortel. The firmware for the IP Phone 1210, 1220 and 1230 is installed automatically during deployment.
.
Analysis:
UNIStim firmware release 3.1 for IP Phones delivers enhancements to Nortel's IP Telephony Solution and delivers
general quality improvements.
The enhancements available with UNIStim firmware release 3.1 for IP Phones include:
- Support for USB Audio on the IP Phone 1120E, 1140E and 1150E
- Support for secure connection between GXAS (graphics-based) Application Servers and the IP Phone 1120E and
1140E
- Auto-provisioning support for Network Port Speed and Network Port Duplex Mode
.
>TECHNICAL SUPPORT
. SOFTWARE UPGRADE BULLETIN
.
.
UNIStim Firmware Release 3.1 for IP Phones