2. Racelogic
  3. LabSat 3

Racelogic LabSat 3 Quick start guide

  • I'm a chat assistant that has analyzed the LabSat 3 user guide and is ready to answer all of your questions about the device. The guide outlines the steps for recording and replaying GNSS signals, including antenna connections, SD card usage, and button functions.
  • How to record GNSS signals?
    What is the purpose of recording at least 4 minutes of stationary data?
    How to replay GNSS signals?
LabSat 3 Record
1. Connect the antenna to the ‘RF IN’ port on the
rear of the LabSat 3.
3. Insert SD card into the LabSat 3.
2. Place the antenna in the middle of the car roof.
4. Press the ‘REC’ button.
5. Drive desired route. Tip: Record at least 4
minutes of stationary data to allow for
acquisition later.
6. Press the ‘REC’ button again to stop
recording.
Find the full manual on the USB hard disk drive.
LabSat 3 Replay
1. Insert SD card into the LabSat 3. Three demo
scenarios are pre-loaded on the SD card.
3. Use the up and down arrows to select the
desired scenario.
2. Connect the device under test to the ‘RF OUT’
port.
4. Press the ‘Play’ button.
Find the full manual on the USB hard disk drive.
/