2. Crown Automotive
  3. Fender Flare Kit J8997109

Crown Automotive Fender Flare Kit J8997109 Operating instructions

  • Hello! I've reviewed the Installation Procedure for the Crown Fender Extension 8997109. This document describes the steps required to properly install the fender extension, including drilling instructions and the use of clamping devices. I'm ready to answer your questions about installation of this product.
  • What size drill bit is required?
    How many mounting holes are there?
    What type of clamping device is suggested?
Crown Automotive SAleS Co., inC.
Fender extension Kit
replACeS pArt #: 8997109
installation Procedure
uSing the reSpeCtive fender extenSion for eACh wheel
opening, poSition the extenSion firmly into the opening.
ClAmp the fender extenSion flAnge to the fender opening
flAnge with A viCe gripS, or SimilAr ClAmping deviCe (See
illuStrAtion).
with the extenSion Serving AS A templAte, mArk the loCAtion
of the AttAChing holeS onto the fender.
drill A 7/32” hole At eACh of the Seven (7) mounting
loCAtionS.
fASten with the SCrewS And plAStiC nutS provided. the
wASher heAd SCrewS Should be inStAlled AS Shown in the
illuStrAtion below.
Fender
/