ECOWITT WH40 heightening block User manual

I have analyzed the provided user manual for the WH40 heightening block. I understand the assembly process, which involves using stainless steel cable ties to connect the rubber module and heightening block and mount bird pricklers. I am ready to answer your questions about this product.
How do I connect the rubber module?

How should the heightening block be oriented?

What tool is recommended for tightening the cable ties?

Step1: Connect the First Rubber Module

Note1:

Please place the stainless steel cable tie

and the rubber protrusion on the same

surface

Note2:

Mounting holes for Bird Pricklers

Step2: Use the Stainless Steel Cable Tie to Connect the

Rubber Module with the Heightening Block

Note3:

Pass the steel cable tie through the

mounting holes on the block

Enter from hole A and exit from hole B

Note1:

Use a stainless steel cable tie to connect the block and

6 rubber module

Heightening Block Rubber Module

Insert strip

Note2:

Mounting holes for bird pricklers

must be set facing up

End-to-End Connection

for steel cable tie

End-to-End Connection for heightening

block with insert strip inward

Step3: Tie the Heightening Block on Rain Cylinder Funnel

Tighten the steel cable tie by hand after the connection

Step4: Tighten the Steel Cable Tie with Needle Nose Pliers

Turn counterclockwise to tighten the steel cable tie

Step5: Mount Bird Pricklers to Finish

Mount bird pricklers, 12 in all

/

Other documents