Wolf Range VC Series Bulletin Manual

ATTENTION: SERVICE MANAGER - PARTS MANAGER

SERVICE BULLETIN – SB1011

DATE:

14 July 2011

TO:

VULCAN AND WOLF CONTRACTED PARTS AND SERVICE AGENCYS

HOBART BRANCHES AND AGENCYS

FROM:

Ronald Arrington

SUBJECT:

Preventive Maintenance – Convection Ovens

Model Numbers Affected

All VC and SG series convection ovens.

Problem:

The air intake perforations located in the lower left corner of the back panel assembly

may become clogged with grease or debris. This restricts both cooling and combustion

air causing possible component failure and intermittent ignition failures.

Tools

Not required.

Action

As a quarterly maintenance procedure and after each service, use a damp rag and

clean blockage from air intake.

If you have any questions contact Ray Boyle at Vulcan Technical Service.

800-814-2028 select 1224

EG COOKING/FULL KITCHEN EQUIPMENT / JULY 2008

Service Information

AIR INTAKE

PERFORATIONS

MUST BE FREE OF

ANY GREASES OR

DEBRIS. KEEP IT

CLEAN AT ALL THE

TIMES.