Rust-Oleum Automotive 261195 User manual

Type
User manual

This manual is also suitable for

Rust-Oleum Automotive 261195 is a low VOC epoxy and lacquer thinner designed for use with most lacquer-based wood and metal finishes. It is compatible with acrylic, epoxies, automotive, or other specialty lacquers. Use the thinner to improve leveling and reduce viscosity without affecting clarity and gloss. Follow the paint manufacturer's instructions for proper reduction ratios.

Rust-Oleum Automotive 261195 is a low VOC epoxy and lacquer thinner designed for use with most lacquer-based wood and metal finishes. It is compatible with acrylic, epoxies, automotive, or other specialty lacquers. Use the thinner to improve leveling and reduce viscosity without affecting clarity and gloss. Follow the paint manufacturer's instructions for proper reduction ratios.

TECHNICAL DATA ATO-46
AUTOMOTIVE LOW VOC
EPOXY & LACQUER THINNER
Form: GDH-36
Rev.: 040813
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Low VOC Epoxy & Lacquer Thinner is a blended,
low VOC solvent designed for use with most lacquer based
wood and metal finishes. Lacquer Thinner is compatible with
acrylic, epoxies, automotive or other specialty lacquers. It is
suitable for thinning lacquer based paints, epoxies, and clear
finishes to improve leveling and reduce viscosity without affecting
clarity and gloss. Carefully read all directions, notes and cautions
prior to use.
.PRODUCTS .
SKU Description
261195 1-Gallon
261196 1-Quart
..PRODUCT APPLICATION .
INSTRUCTIONS
Use only with adequate ventilation. Always follow the paint
manufacturer’s instructions for proper reduction ratios. Do not
use more than recommended. Protect hands with solvent-
resistant gloves and eyes with safety glasses. Add gradually and
stir until desired consistency is obtained. Excessive amounts
may decrease hiding power or cause blushing. Clean brushes
and spray equipment as long as lacquer remains wet on the
tools. Do not use to remove large areas of carpet adhesive,
asphalt tile or carpet cement. For this use a non-flammable
remover. Do not use on rubber, plastic, linoleum or synthetic
bristle brushes.
NOTE: Lacquer Thinner is extremely flammable and should not
be used for cleaning or degreasing large areas. If you are using
this product in the workplace, read the Material Safety Data
Sheet before using.
TECHNICAL DATA
AUTOMOTIVE LOW VOC EPOXY & LACQUER THINNER
Rust-Oleum Corporation Form: GDH-36
11 Hawthorn Parkway Phone: 877•3858155 Rev.: 040813
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
LOW VOC EPOXY & LACQUER THINNER
Solvent Type
Contains Acetone and Oxsol
Weight
Per Gallon
7.00 lbs.
Per Liter
0.84 kg
VOC
0 g/l
Shelf Life
5 years
Flash Point
-4°F (-20°C)
Safety Information
FOR ADDITIONAL INFORMATION, SEE MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.
  • Page 1 1
  • Page 2 2

Rust-Oleum Automotive 261195 User manual

Type
User manual
This manual is also suitable for

Rust-Oleum Automotive 261195 is a low VOC epoxy and lacquer thinner designed for use with most lacquer-based wood and metal finishes. It is compatible with acrylic, epoxies, automotive, or other specialty lacquers. Use the thinner to improve leveling and reduce viscosity without affecting clarity and gloss. Follow the paint manufacturer's instructions for proper reduction ratios.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI