About Warnings
WARNING: A WARNING indicates a potential for property damage, personal injury,
or death.
Mounting Your Dell™ OptiPlex™ XE Using
a Wall-Mount Unit
WARNING: Before working inside your computer, read the safety information that
shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: The size of the wall-mount unit differs based on the computer’s form factor.
1
If you are mounting a computer with the optional Ingress Protection 51 (IP51)
kit attached, remove the paddings from the wall-mount unit.
February 2010
2
Mount the wall-mount unit to the wall using the screws that shipped with
the unit.
3
Place the computer into the wall-mount unit.
Without the IP51 kit With the IP51 kit
____________________
Information in this document is subject to change without notice.
© 2010 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is
strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, and OptiPlex are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the
marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade
names other than its own.
4
Replace the two screws on the wall-mount unit.
Without the IP51 kit With the IP51 kit
-
1
-
2
-
3
-
4
Dell OptiPlex XE (Early 2010) User guide
- Type
- User guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Eurotherm IP51/52-IP61/62 Series Owner's manual
-
iHome iP51 User manual
-
Axis 0443-002 Datasheet
-
GE LWW Series Installation guide
-
-
-
CARLO GAVAZZI EM33DINAV33XXSPF Installation guide
-
-
-