Question?
Contact
Philips
Question?
Contact
Philips
www.philips.com/support
BTB2462
2015 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility of
Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation
to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips N.V. and are used under license from Koninklijke Philips N.V.
BTB2462_05_Short User Manual_V1.0
Short User Manual
Short user manual
www.philips.com/support
Always there to help you
Register your product and get support at
Question?
Contact
Philips
Wall Mounting Instructions
Philips BTB2462
1 Press /PAIRING to select the Bluetooth source.
» The Bluetooth indicator ashes blue quickly.
2 On your device,search for Bluetooth devices that can be paired.
3 Select ‘Philips BTB2462‘ on your Bluetooth enabled device and if
necessary input ‘0000’ as the paring password.
» After successful pairing and connection, the Bluetooth indicator
turns solid blue, and the unit beeps twice.
4 Play music on the connected device.
Note:
• You can pair and connect a maximum of 3 devices to this
product at the same time.
• If you fail to search for ‘Philips BTB2462‘ or cannot pair with
this product, press and hold
/PAIRING for three seconds
to enter pairing mode.
3
/
Select a folder.
/
Select an audio le.
Pause or resume play.
/MENU
Stop play.
MODE Select an available play mode.
• [REPEAT ONE] (repeat one): repeat the
current track
• [REPEAT ALB] (repeat album): repeat
tracks in the current album
• [REPEAT ALL] (repeat all): repeat all
tracks
• [SHUFFLE ON] (shufe on): play tracks
randomly
• [OFF] (off): play tracks in sequence
Switch to standby mode
Switch to ECO standby mode
Store DAB+ radio stations automatically Store DAB+ radio stations manually Use DAB+ menu
Repeat step 2-3 to set hour, minute, and whether to
synchronize the clock with an RDS radio or a DAB+
station that transmits time signals.
3
1 Press and hold CLOCK/SCAN for more than 3 seconds.
2 Press / to select an automatically store station.
1 Tune to a DAB+ radio station.
2 Press PROG to activate the storing mode.
3 Press / to select a preset number.
4 Press PROG to conrm.
» The name of the preset station is displayed.
Specications
Amplier
Rated Output Power 2 x 5 W
Frequency Response 63 -20KHz, ±3dB
Total Harmonic Distortion <1%(1 KHz)
Signal to Noise Ratio (A-weighted) >72dBA
AUDIO IN 650mV RMS 22kohm
Disc
Laser Type Semiconductor
Disc Diameter 12 cm
Support Disc CD-DA, CD-R, CD-RW,
MP3-CD
Audio DAC 24 Bits/44.1 kHz
Total Harmonic Distortion <1% (1 kHz)
Frequency Response 63Hz - 20kHz, ±3dB
S/N Ratio >72dBA
Bluetooth
Bluetooth version V3.0 +EDR
Bluetooth frequency band 2.4GHz ~ 2.48GHz ISM Band
Range 10 m (free space)
USB
USB Direct Version 2.0 full speed
1 Important
Safety
• Make sure that there is enough free space around the product
for ventilation.
• Only use attachments or accessories specied by the
manufacturer.
• Battery usage CAUTION – To prevent battery leakage which
may result in bodily injury, property damage, or damage to the
product:
• Install the batteries correctly, + and - as marked on the
product.
• Do not mix batteries (old and new or carbon and alkaline,
etc.).
• Remove the batteries when the product is not used for a
long time.
• The batteries shall not be exposed to excessive heat such
as sunshine, re or the like.
• Use only power supplies listed in the user manual.
• The product shall not be exposed to dripping or splashing.
• Do not place any sources of danger on the product (e.g. liquid
lled objects, lighted candles).
• Where the mains plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
Warning
• Never remove the casing of this device.
• Never lubricate any part of this device.
• Never place this device on other electrical equipment.
• Keep this device away from direct sunlight, naked ames or heat.
• Never look into the laser beam inside this device.
• Ensure that you always have easy access to the power cord, plug, or adaptor
to disconnect this device from the power.
Hearing safety
A pleine puissance, l’écoute prolongée du baladeur
peut endommager l’oreille de l’utilisateur.
Listen at a moderate volume.
• Using headphones at a high volume can impair your hearing. This
product can produce sounds in decibel ranges that may cause
hearing loss for a normal person, even for exposure less than a
minute. The higher decibel ranges are offered for those that may
have already experienced some hearing loss.
• Sound can be deceiving. Over time your hearing ‘comfort level’
adapts to higher volumes of sound. So after prolonged listening,
what sounds ‘normal’ can actually be loud and harmful to your
hearing. To guard against this, set your volume to a safe level
before your hearing adapts and leave it there.
To establish a safe volume level:
• Set your volume control at a low setting.
• Slowly increase the sound until you can hear it comfortably and
clearly, without distortion.
Listen for reasonable periods of time:
• Prolonged exposure to sound, even at normally ‘safe’ levels, can
also cause hearing loss.
• Be sure to use your equipment reasonably and take appropriate
breaks.
3
Make sure that the clock is set correctly.
1 In standby mode, press and hold SLEEP/TIMER for three
seconds.
2 Press / (or SOURCE) repeatedly to select an
alarm source (DISC, USB, DAB, TUNER ).
3 Press SLEEP/TIMER to conrm.
4 Repeat steps 2-3 to set hour, minute, and adjust volume of
the alarm.
3
Tune to FM radio stations Store FM radio stations automatically Store FM radio stations manually
Press SLEEP/TIMER repeatedly to select a set period of time
(in minutes).
» When the sleep timer is activated, [SLEEP] is displayed.
Tuner (FM)
Tuning Range 87.5-108 MHz
Tuning grid 50 KHz
Sensitivity
- Mono, 26 dB S/N Ratio
- Stereo, 46 dB S/N Ratio
<22 dBf
<43 dBf
Search Selectivity <28dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >55dBA
DAB
DAB Range 174.928MHz - 239.200MHz
General information
AC power MODEL: GT-WAHU12000250-002/
AS360-120-AI250
Input: 100-240V~, 50-60 Hz
Output: DC 12V, 2500 mA
Operation Power
Consumption
15W
Eco Standby Power
Consumption
0.5W
Dimensions
- Main Unit (W x H x D)
465 x 233 x 107 mm
Weight
- Main Unit
2.4 kg
Be sure to observe the following guidelines when using your
headphones.
• Listen at reasonable volumes for reasonable periods of time.
• Be careful not to adjust the volume as your hearing adapts.
• Do not turn up the volume so high that you can’t hear what’s
around you.
• You should use caution or temporarily discontinue use in
potentially hazardous situations.
2 Notice
Any changes or modications made to this device that are not
expressly approved by Gibson Innovations may void the user’s
authority to operate the equipment.
Declaration of conformity
Hereby, Gibson Innovations declares that this product is in compliance
with the essential requirements and other relevant provisions of
Directive 1999/5/EC. You can nd the Declaration of Conformity on
www.p4c.philips.com.
Disposal of your old product and battery
Your product is designed and manufactured with high
quality materials and components, which can be recycled
and reused.
This symbol on a product means that the product is
covered by European Directive 2012/19/EU.
This symbol means that the product contains batteries
covered by European Directive 2013/56/EU which cannot be
disposed of with normal household waste.
Inform yourself about the local separate collection system for
electrical and electronic products and batteries. Follow local rules and
never dispose of the product and batteries with normal household
waste. Correct disposal of old products and batteries helps prevent
negative consequences for the environment and human health.
Removing the disposable batteries
To remove the disposable batteries, see battery installation section.
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Important notes for users in the U.K.
Mains plug
This apparatus is tted with an approved 13 Amp plug. To change a
fuse in this type of plug proceed as follows:
a Remove fuse cover and fuse.
b Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or
BSI approved type.
c Ret the fuse cover.
If the tted plug is not suitable for your socket outlets, it should be cut
off and an appropriate plug tted in its place.
If the mains plug contains a fuse, this should have a value of 3 Amp. If
a plug without a fuse is used, the fuse at the distribution board should
not be greater than 3 Amp.
Note: The severed plug must be disposed off to avoid a possible shock
hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue
= neutral (N), brown = live (L).
As these colours may not correspond with the colour markings
identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured
black.
• Connect the brown wire to the terminal marked L or coloured
red.
• Do not connect either wire to the earth terminal in the plug,
marked E (or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is
clamped over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. see Copyright
Act 1956 and The performer’s Protection Acts 1958 to 1972.
This item incorporates copy protection technology that is protected
by U.S. patents and other intellectual property rights of Rovi
Corporation. Reverse engineering and disassembly are prohibited.
The Bluetooth® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by Gibson is
under license. Other trademarks and trade names are those of their
respective owners.
This apparatus includes this label:
Note
• The type plate is located on the back of the device.
To download the full user manual, visit www.philips.com/support.
User Manual
www.philips.com/support
Always there to help you
Register your product and get support at
Question?
Contact
Philips
PDF
www.philips.com/support.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Philips AQ1001/05 Quick start guide
-
-
-
-
-
-
Philips SPA35W/94 User manual
-
-
-
Philips AE2600B/12 User manual