Maytag FS5BD Product information

Brand: Maytag

Model: FS5BD

Type: Product information

Single Phase

1. Couper le courant avant de faire letretien.

2. Employez uniquement des conducteurs

en cuivre.

3. Ne convient pas aux installations

de plus de 150 volt a la terre.

710570B

(Replaces 710570A)

0109

WIRING DIAGRAM

Split System Air Conditioner (Outdoor Section)

NOTES:

1. Disconnect all power before servicing.

2. For supply connections use copper conductors only.

3. Not suitable on systems that exceed 150 volts to ground.

4. For replacement wires use conductors suitable for 105 deg C.

5. For ampacities and overcurrent protection, see unit rating plate.

6. Connect to 24 vac/40ca/class 2 circuit. See furnace/airhandler installation

instructions for control circuit and optional relay/transformer kits.

7. Anti-Short Cycle Timer (ASCT) may or may not be installed in the unit. If desired,

ASCT is factory installed on select models only or may be field installed as shown using

manufacturer’s approved kit. If not present, connect Yellow and Black wires per Note 6.

8. DO NOT use a Hard Start Kit on a model with a PTCR installed.

FIELD WIRING

LEGEND:

LOW VOLTAGE

HIGH VOLTAGE

CC - Contactor Coil

CCH - Crankcase Heater

HPS - High Pressure Switch

208/230V

ASCT

(SEE NOTE 7)

CCH

(OPTIONAL)

COMPRESSOR

CONTACTS

COMPRESSOR

OUTDOOR FAN

MOTOR

24 VOLT FIELD

CONNECTIONS

¢710570|¤

PTCR (If equipped)

ASCT

(SEE

NOTE 7)

GROUNDING

SCREW

L1 L2

GND

OUTDOOR

FAN MOTOR

DUAL

CAPACITOR

START

CAPAC

START

RELAY

CONTACTOR

CRANKCASE

HEATER

(OPTIONAL)

SEE NOTE 6

Optional Hard Start Kit

to “H” on capacitor

to T2 on

contactor

to “C” on

capacitor

PTCR

(if equip)

BLACK

BLUE

ORANGE

YELLOW

BLACK

RED

YELLOW

BLACK

RED OR

YELLOW

BLACK

RED OR

RED BLACK

BLACK OR

BLK WHT

YELLOW

BLACK

RED OR

RED BLACK

YELLOW

Maytag FS5BD Product information

Maytag FS5BD Product information

Maytag FS5BD Product information

Related papers

Other documents