2. Home
  3. Home security & automation
  4. Security device components
  5. Metra
  6. MPS-UNDG-KT1

Metra MPS-UNDG-KT1 Operating instructions

  • Hello! I've reviewed the Metra's MPS-UNDG-KT1 Underglow Kit install instructions. This document details how to install the six LED tubes, including clamp placement and wiring instructions, turn signals and brake light options. It is also mentions the HEISE Connect App. I'm ready to answer your questions about the kit.
  • How many clamps are needed for the side tubes?
    How many clamps are needed for front and rear tubes?
    How often should the cables be secured?
    What app can be used to control the lights?
L2
R2
R3
R4
R5
R6
L3
L4
L5
L6
2 Clamps
4 Clamps
Heise
Controller
R=Right
L=Left
MPS-UNDG-KT1
MetraOnline.com
Date: 10/2022 REV.1
Having difficulties?
Contact our tech support line at:
Techsupport@metra-autosound.com
Or via phone at:
368.257.1187
Installation Instructions
Review the vehicle and locate suitable places to mount the six
LED tubes. Avoid locations that are hot, move, pinch points,
the gas tank, and gas lines.
1. Side tubes get 4 clamps; front and rear tubes get 2
clamps. Try to evenly space the clamps, and do not
position the clamp directly over an LED.
2. Starting at the controller connect the left extension
(driver side) and route to the front left tube. orientating
the tube as shown.
3. Mount the tube with supplies hardware, and secure the
cable every 12 inches with the included zip-ties.
4. Continue to connect the tubes and extensions, matching
the flag labels, and mounting the tubes as you go.
0
RGB Controller:
• Scan QR code to download HEISE Connect app.
MPS-PRSP
2020-UP Polaris Ranger XP | Install instructions
MPS-UNDG-KT1
Underglow Kit w/Controller | Install instructions
3
3
4
5
Screw
T25
MetraOnline.com
Technical Support: 386-257-1187
Step 9
Step 13
The controller has the option for turn signal and brake functions. By connecting the
following wires, the whip will flash amber with vehicle's turn signal, and illuminate red
when braking.
Green wire - Left turn signal (+12VDC)
Yellow wire - Right turn signal (+12VDC)
White wire - Brake light (+12VDC)
Speed Adjustment
Brightness Adjustment
Press and hold for 5 seconds to lock
controller to work only with this remote.
(app control will continue to function)
Demo Mode
Power Off
Change Mode
Single Color
Press and hold for 5 seconds to unlock
controller from remote.
(Allows controller to work with multiple remotes.)
/