PNI ML75 CB Antenna is a CB radio antenna compatible with any CB radio. It is very easy to install, you can fix it on a threaded magnetic base or connect it to a support with a connecting cable. Once installed, you'll need to connect it to a CB radio (plug not included) and test the SWR in an open area using a reflectometer. Depending on the result, it may be necessary to raise or shorten the wire to get an optimal SWR value. The antenna has a frequency range of 26 – 28 MHz, SWR ≤ 1.2:1, impedance of 50 Ohm, length of 850 mm, and a tilt angle of 0 - 90°. The maximum supported power is 40 W continuous and 300 W for a short time.
PNI ML75 CB Antenna is a CB radio antenna compatible with any CB radio. It is very easy to install, you can fix it on a threaded magnetic base or connect it to a support with a connecting cable. Once installed, you'll need to connect it to a CB radio (plug not included) and test the SWR in an open area using a reflectometer. Depending on the result, it may be necessary to raise or shorten the wire to get an optimal SWR value. The antenna has a frequency range of 26 – 28 MHz, SWR ≤ 1.2:1, impedance of 50 Ohm, length of 850 mm, and a tilt angle of 0 - 90°. The maximum supported power is 40 W continuous and 300 W for a short time.
PNI ML75 CB Antenna is a CB radio antenna compatible with any CB radio. It is very easy to install, you can fix it on a threaded magnetic base or connect it to a support with a connecting cable. Once installed, you'll need to connect it to a CB radio (plug not included) and test the SWR in an open area using a reflectometer. Depending on the result, it may be necessary to raise or shorten the wire to get an optimal SWR value. The antenna has a frequency range of 26 – 28 MHz, SWR ≤ 1.2:1, impedance of 50 Ohm, length of 850 mm, and a tilt angle of 0 - 90°. The maximum supported power is 40 W continuous and 300 W for a short time.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI