Page is loading ...
ASSEMBLY INSTRUCTIONS
1/7
PARTS
1
2
Seat Body
QTY:1 Backrest
QTY:1
7
Arm Leg
QTY:4
M10 Washer
(Outer Dim : 45mm
QTY:4
QTY:1 Pair
2/7
3
Cushion
QTY: 3
4
5
6
QTY: 2
Pillow
Step 1 : Carefully unpack parts/hardwares from box and storage of seat body, place them on a clean flat surface.
HARDWARE
Storage,
underneath of sofa body.
3/7
Step 2 : Place both arms as shown below, secure two legs and plastic washers into pre-drilled holes on the bottom
of arms. Please avoid over tightening.
5
× 4
6 × 4
5
6
4/7
Step 3 : Carefully lift and turn assembled arms onto its legs. Insert seat body metal plates to both arms as shown below.
Ensure it is correctly in place.
3
5/7
Step 4 : Insert backrest metal plates to both arms as shown below. Ensuring it is correctly in place.
3
6/7
Step 5: Finally, stretch and pull down rear cover evenly before securing velcro strip to seat base. Repeat if necessary
for better fit.
7/7
/
