Astria Fireplaces DRL2000 Instruction Sheet
- Category
- Fireplaces
- Type
- Instruction Sheet
This manual is also suitable for
1
HeatFlo™
Cover Plate Repair Kit
INSTALLATION INSTRUCTIONS FOR THE HEATFLO COVER PLATE REPAIR KIT
[FOR USE WITH MODELS: Compass45TEN, CompassDLX45TEN, Compass55TEN, CompassDLX55TEN, DRL2000 45/55 and DRL3500 45/55]
HEARTH PRODUCTS
KITS AND ACCESSORIES
P/N 901066-00
REV. NC 03/2021
HeatFlo Cover Plate Repair Kit
Cat. No. Description
F4579 HeatFlo Cover Plate Repair Kit
KIT CONTENTS
4 ea. Cover Plate for cabinet top
4ea. Cover plate for inner heat reflector
4ea. Insulation plugs
4 ea. Fasteners
1 ea. Instruction Sheet
TOOLS / SUPPLIES REQUIRED
5/16” Nut Driver, 6” Minimal Length
PPE: Safety Glasses, Cut Resistant Gloves and Sleeves
GENERAL INFORMATION
The HeatFlo Cover Plate Kit is intended to safely repair the fireplace
in case it was prepared for a HeatFlo Kit and it will not be used.
READ ALL THE STEPS BEFORE STARTING THE INSTALLATION
THE FIREPLACE MUST BE OFF AND COLD BEFORE BEGINNING.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE
INSTALLATION AND OPERATION MANUAL PROVIDED WITH
THE APPLIANCE APPLY TO THESE INSTRUCTIONS.
If you encounter any problems, need clarification of these
instructions or are not qualified to properly install this kit,
contact you local distributor or dealer.
If any of these parts are missing or damaged, contact your
dealer or IHP.us.com for referral information.
Figure 1 - Kit Contents
Figure 2 - Cover Plates
INSTALLATION INSTRUCTIONS
1. Install one (1) small cover plate from above the unit by posi-
tioning the cover down through the cabinet top and the insu-
lation (see Figure 2).
2. Place the joggle through the hole where the knockout was
removed (see Figure 2).
Self-Tapping Screws
NOTE: Cabinet Top and Insulation
Removed for Clarity.
2
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Printed in U.S.A. © 2021 Innovative Hearth Products
P/N 901066-00 REV. NC 03/2021
Innovative Hearth Products (IHP) reserves the right to make changes at any time, without notice,
in design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
1769 East Lawrence Street • Russellville, AL 35654
3. Hold cover plate flat, flush with inner heat reflector, and install
self-tapping screw.
4. Repeat 3 more times.
5. Insert the replacement insulation “plugs” between inner heat
reflector and cabinet top.
6. Install large cover plates on cabinet top by placing joggle down
inside the hole where the knockout was removed.
7. Hold cover plate flat, flush with cabinet top, and install self-tap-
ping screw.
8. Repleat 3 more times.
9. Complete.
Self-Tapping Screws
Figure 3 - Cover Plates
-
1
-
2
Astria Fireplaces DRL2000 Instruction Sheet
- Category
- Fireplaces
- Type
- Instruction Sheet
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Superior Fireplaces VRL3000 Operating instructions
-
-
-
-
-
-
-
-
-