8.4 Auto Off function
To decrease the energy consumption, the
Auto Off function turns the appliance off
automatically:
• if the Start/Pause touch button
is not touched within 5 minutes.
• 5 minutes after a cycle ends.
Push the
ON/OFF button to turn on the
appliance.
If the appliance is on, some indications
appear on the display.
8.5 Setting a programme
Use the programme button to set the
programme.
The display shows cycle time or price to
start.
8.6 Starting a programme
To start the programme:
1. Insert correct amount of coins as on
the display.
2. Push the Start/Pause button.
The appliance starts and the LED above
the button stops ashing and stays on.
8.7 Program change
To change a program:
1. Push the
ON/OFF button to turn
the appliance off.
2. Push the ON/OFF button again to
turn on the appliance.
3. Set a new program.
8.8 Programme end
Clean the lter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is completed, the
symbol ashes on the display and the
acoustic signal sounds intermittently for 1
minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the
ON/OFF
button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
9. HINTS AND TIPS
9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which are
specied in the programmes chapter.
• Clean the lter after each drying cycle.
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• The water from the water container can
be used to iron the clothes. You must
rst lter the water to eliminate
remaining textile bres (simple coffee
lter is suitable).
• Always keep the airow slots at the
bottom of the appliance clear.
• Make sure there is good airow where
the appliance is to be installed.
14