2. Genmitsu
  3. 4040 PRO Hybrid Spoilboard

Genmitsu 4040 PRO Hybrid Spoilboard Installation guide

  • Hello, I've reviewed the Genmitsu 4040 PRO Hybrid Spoilboard Installation Guide. This document provides instructions on how to assemble the hybrid spoilboard using aluminum and MDF slats, screws, and an allen wrench. It contains details on how to correctly install the slats and a cautionary note on screw alignment. I'm ready to help answer any questions you have about this product or its installation.
  • What tools are required for the installation?
    What type of screws are used?
    What should I do if some screws can not be locked?
Genmitsu
4040 PRO Hybrid Spoilboard Installation Guide
Unboxing
01
① (3) Aluminum & MDF Hybrid Slat
③ (2) Narrow MDF Slat
⑤ (9) M5x16 Hex Socket Cap Screw
(5) M5Χ25 Hex Socket Cap Screw
④ Allen Wrench
2mm, 3mm, 4mm
② (2) Wide MDF Slat
⑥ (19) M3Χ18 Flat
Head Cap Screw
Dimension
02
420mm
600mm
PART 1: Remove the Original Platforms
1. Remove the screws from the original platform, as shown.
03
PART 1: Remove the Original Platforms
2. Remove original MDF boards.
04
05
PART 2: Install the Hybrid Slat
Step 1: Install Aluminum Modules
1. Place the aluminum & MDF hybrid slats on the profile frame as shown
below, align the hybrid slat over-holes with the corresponding screw holes.
2. Secure the slats with (8) M5x16 hex socket cap screws.
Tip: To avoid affecting the installation of the following slats, please make
sure that the screw holes are correctly aligned.
① (3) Aluminum & MDF Hybrid Slat ⑤ (9) M5x16 Hex
Socket Cap Screw
06
PART 2: Install the Hybrid Slat
Step 2: Install Narrow MDF Slats
1. Place the narrow MDF slats as shown below, then align the narrow MDF
slat over-holes with the corresponding screw holes.
2. Secure the slats with (4) M5 x 25 hex socket cap screws.
① (2) Narrow MDF Slat ⑤ (4) M5x25 Hex Socket Cap Screw
07
PART 2: Install the Hybrid Slat
Step 3: Install Wide MDF Slats
1. Place the wide MDF slats into aluminum & MDF hybrid slat recesses as
shown below, then align the wide MDF slat over-holes with the corresponding
screw holes.
Tip: Surface with counterbore facing up.
2. Secure the slats with (19) M3x18 flat head cap screws.
① (2) Narrow MDF Slat ⑤ (19) M3Χ18 Flat Head Cap Screw
08
PART 3: Cautionary Note
In the assembly process, if you find that there are screws that can not be
locked into, you should first loosen all the fixed screws on the extended
aluminum table (counterclockwise rotation of 2-3 turns), to re-adjust the
position between the aluminum & MDF hybrid slats and the MDF slats to
make the screw can be locked in.
Genmitsu
If you need any assistance, please contact us via:
Email: support@sainsmart.com
Facebook messenger: https://m.me/SainSmart
Help and support is also available from our Facebook Group
/