Geek Chef GCF20A User guide

Brand: Geek Chef

Model: GCF20A

Category: Coffee makers

Type: User guide

QUICK START GUIDE

THE FIRST TIME OR A LONG TIME NOT USE THE MACHINE

1Make sure to tear off the

sealing tape from the botton

of the water tank. (If it has

been taken off, please skip

this step)

5Place a big cup under the

steam wand. Rotate the

knob to steam position

when it is on standby

mode.

6The Single cup coffee

indicator will turn on, press

Single cup coffee button to

make hot water from the

steam wand.

7Let the water flow out about

30s-60s, rotate the knob back

to the "0" position to stop.

This process is let the water

flow into the empty pump for

the first use.

2Make sure the steam wand

nozzle is clean and no

blocking.

3Fill water into the water tank

NOT exceed the MAX line.

Set up the water tank

verticallyand align the buckles

to the hole on the back of the

machine, and press it down to

be parallel to the top of the

machine.

4Plug in the power cord, press

power switch to the "on"

position, all blue indicator lights

will flash as the machine starts

heating until the coffee button

indicators stay on.

Retain this instruction for future reference.

8Place a cup on the drip tray,

rotate the knob to the coffee

brewing side.

9Press the Single or Double

cup coffee button to flow out

hot water to clean the filter

holder or the coffee cup. After

the water stop flowing, rotate

the knob to "0" position.

MAKE ESPRESSO ALONE

Insert the filter into the

filter holder. Fill ground

coffee into the filter and

press it with the tamp

spoon. The ground

coffee should be pressed

evenly and not too firmly.

Install the filter holder

into the machine from

"Unlock" to "Lock"

position. Place a cup on

the drip tray.

Rotate the knob to the

coffee brewing side.

After the coffee

indicators stop flashing,

press Single cup or

Double cup coffee

button to start brewing.

The machine will stop

automatically when

coffee brewing finished.

Rotate the knob back to

the "0" position.Enjoy

your espresso.

1

5

2 3

4

FROTH MILK ALONE

At the standby mode,

press Steam button, the

Steam indicator will

flash as steam preheat-

ing. When the indicator

stays on, it means

machine is ready to

steam.

Froth milk in the way

moving pitcher round

from up to down, after

the milk increase in

volume by 2 times or the

required purpose is

reached, turn the knob

back to "0" position to

stop. Take away the

pitcher.

In order to prevent the

steam wand nozzle

from blocking and

make it easier to clean,

we suggest you to

clean it immediately

after frothing milk.

Press and hold the steam wand, pull out the stainless steel

sleeve. Clean the steam nozzle with a damp cloth/sponge.

Prepare a pitcher with

about 100ml of cold

milk.Insert the steam

wand nozzle into the

milk about 0.4~0.8 inch.

Slowly turn on the steam

control knob to control

the steam volume.

Rotate the knob to the

steam position. The

steam indicator will turn

on. The machine will

start making steam out

of steam wand nozzle.

NOTE:During the milk

frothing, if lack of water, the

machine will produce louder

noise and small steam,

please refill in time.

1 2 3

45

6

---------------------------------------------------------

Retain this instruction for future reference.

1
2

Geek Chef GCF20A User guide

Brand: Geek Chef

Model: GCF20A

Category: Coffee makers

Type: User guide

Other documents