QUICK START GUIDE
THE FIRST TIME OR A LONG TIME NOT USE THE MACHINE
1Make sure to tear off the
sealing tape from the botton
of the water tank. (If it has
been taken off, please skip
this step)
5Place a big cup under the
steam wand. Rotate the
knob to steam position
when it is on standby
mode.
6The Single cup coffee
indicator will turn on, press
Single cup coffee button to
make hot water from the
steam wand.
7Let the water flow out about
30s-60s, rotate the knob back
to the "0" position to stop.
This process is let the water
flow into the empty pump for
the first use.
2Make sure the steam wand
nozzle is clean and no
blocking.
3Fill water into the water tank
NOT exceed the MAX line.
Set up the water tank
verticallyand align the buckles
to the hole on the back of the
machine, and press it down to
be parallel to the top of the
machine.
4Plug in the power cord, press
power switch to the "on"
position, all blue indicator lights
will flash as the machine starts
heating until the coffee button
indicators stay on.
Retain this instruction for future reference.
8Place a cup on the drip tray,
rotate the knob to the coffee
brewing side.
9Press the Single or Double
cup coffee button to flow out
hot water to clean the filter
holder or the coffee cup. After
the water stop flowing, rotate
the knob to "0" position.
MAKE ESPRESSO ALONE
Insert the filter into the
filter holder. Fill ground
coffee into the filter and
press it with the tamp
spoon. The ground
coffee should be pressed
evenly and not too firmly.
Install the filter holder
into the machine from
"Unlock" to "Lock"
position. Place a cup on
the drip tray.
Rotate the knob to the
coffee brewing side.
After the coffee
indicators stop flashing,
press Single cup or
Double cup coffee
button to start brewing.
The machine will stop
automatically when
coffee brewing finished.
Rotate the knob back to
the "0" position.Enjoy
your espresso.
1
5
2 3
4
FROTH MILK ALONE
At the standby mode,
press Steam button, the
Steam indicator will
flash as steam preheat-
ing. When the indicator
stays on, it means
machine is ready to
steam.
Froth milk in the way
moving pitcher round
from up to down, after
the milk increase in
volume by 2 times or the
required purpose is
reached, turn the knob
back to "0" position to
stop. Take away the
pitcher.
In order to prevent the
steam wand nozzle
from blocking and
make it easier to clean,
we suggest you to
clean it immediately
after frothing milk.
Press and hold the steam wand, pull out the stainless steel
sleeve. Clean the steam nozzle with a damp cloth/sponge.
Prepare a pitcher with
about 100ml of cold
milk.Insert the steam
wand nozzle into the
milk about 0.4~0.8 inch.
Slowly turn on the steam
control knob to control
the steam volume.
Rotate the knob to the
steam position. The
steam indicator will turn
on. The machine will
start making steam out
of steam wand nozzle.
NOTE:During the milk
frothing, if lack of water, the
machine will produce louder
noise and small steam,
please refill in time.
1 2 3
45
6
---------------------------------------------------------
Retain this instruction for future reference.
/