OLG LXHDPKG_3_W User manual

OLG
Brand
OLG
Model
LXHDPKG_3_W
Type
User manual

This manual is also suitable for

Balance Executive with Arms & Lumbar
Assembly Instructions
Balance Executive with Arms & Lumbar Assembly Instructions
2
Components List
Balance Executive with Arms & Lumbar
A
B
C
D
E
F
G
Base
Back Frame
5 x Caster
Left Arm
Hex Wrench
Right Arm
4 x Short Bolt
Seat Pan
2 x Long Bolt
Gas Cylinder
F
A
G
B
H
C
J
D
K
E
Balance Executive with Arms & Lumbar Assembly Instructions
3
Assembly Instructions
Balance Executive with Arms & Lumbar
E
F
G
J
D
J
JJ
STEP 1: STEP 2:
G
Align back frame with pre-located holes
on the seat mechanism
Balance Executive with Arms & Lumbar Assembly Instructions
4
Assembly Instructions
BC
KK
STEP 3: STEP 4:
Balance Executive with Arms & Lumbar
Balance Executive with Arms & Lumbar Assembly Instructions
5
Assembly Instructions
Slip Cover (sold separately)
1. Assemble chair Remove old slip cover and foam from seatpan by
unfastening the velcro fasteners on the back and
front of seat. Remove the back fasteners fi st.
2.
Make sure all four slip cover corners match to
the foam corners, top & bottom. Close zipper
approcimately 2”
5. Align 2 front corners and install using velcro
fasteners. Lift back of seat and zip up slip
cover. Align 2 back corners and install using
velcro fasteners.
6.Install new slip cover onto the foam.5.
Unzip old slip cover and remove from foam.3.
Balance Executive with Arms & Lumbar
Sydney 02 8188 2732
Melbourne 03 9111 0315
Brisbane 07 3733 1923
Adelaide 08 7111 0810
Perth 08 9468 2707
info@olgoffice.com
myolg.online | olgoffice.com | officedesigner.net | motionoffice.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

OLG LXHDPKG_3_W User manual

OLG
Brand
OLG
Model
LXHDPKG_3_W
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents