SERVICE MANUAL
Sony Home Entertainment &
Sound Products Inc.
HT-Z9F/Z9RF/ZF9
SA-Z9F/ZF9
SPECIFICATIONS
HT-Z9F/Z9RF/ZF9
SOUND BAR
SA-Z9F/ZF9
ACTIVE SPEAKER SYSTEM
9-896-492-04
2019E33-1
© 2019.05
US Model
Canadian Model
E Model
Chinese Model
HT-Z9F/SA-Z9F
AEP Model
UK Model
HT-ZF9/SA-ZF9
Australian Model
HT-Z9F/Z9RF/SA-Z9F
Ver. 1.3 2019.05
• Except AUS model
All of the units included in the HT-Z9F (SA-Z9F/SA-WZ9F/Remote control) or HT-ZF9 (SA-ZF9/SA-WZF9/
Remote control) are required to confi rming operation of this unit. Check in advance that you have all of the units.
Also, if the customer are using rear speakers (SA-Z9R(SA-LZ9R/RZ9F)), rear speakers (SA-Z9R (SA-
LZ9R/RZ9F)) are also required.
• AUS model
All of the units included in the HT-Z9RF (HT-Z9F (SA-Z9F/SA-WZ9F/Remote control) and SA-Z9R (SA-LZ9R/
RZ9F)) are required to confi rming operation of this unit. Check in advance that you have all of the units.
COMPONENT MODEL NAME
HT-Z9F HT-ZF9
Bar Speaker (Active Speaker System) SA-Z9F SA-ZF9
Subwoofer (Active Subwoofer) SA-WZ9F SA-WZF9
• HT-Z9RF is package model of HT-Z9F and SA-Z9R (Rear speaker). Please refer to service manual separately issued for SA-Z9R. (AUS only)
• Please refer to service manual separately issued for Subwoofer.
Note:
Be sure to keep your PC used for service and
checking of this unit always updated with the
latest version of your anti-virus software.
In case a virus affected unit was found during
service, contact your Service Headquarters.
Amplifier section
(Z9F: US)
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(FTC)
Front L + Front R:
With 4 ohms loads, both channels
driven, from 200 - 20,000 Hz; rated
35 W per channel minimum RMS
power, with no more than 1% total
harmonic distortion from 250 mW to
rated output.
POWER OUTPUT (reference)
Front L/Front R/Center speaker
blocks: 100 W (per channel at 4 ohms,
1kHz)
(Z9F: CND, AUS, EA, SP, TW, TH, IND, LA/
ZF9)
POWER OUTPUT (rated)
Front L + Front R: 60 W + 60 W
(at 4 ohms, 1 kHz, 1% THD)
POWER OUTPUT (reference)
Front L/Front R/Center speaker
(Z9F: CH)
POWER OUTPUT (rated)
Front L/R speakers: 60 W
(per channel at 4 ohms, 1 kHz)
Center speaker: 60 W
(per channel at 4 ohms, 1 kHz)
blocks: 100 W (per channel at 4 ohms,
1kHz)
Inputs
HDMI IN 1/2*
ANALOG IN
TV IN (OPT)
Outputs
HDMI OUT (TV eARC/ARC)*
* HDMI IN 1/2 and HDMI OUT (TV eARC/
ARC) jacks support HDCP 2.2 protocol.
HDCP 2.2 is newly enhanced copyright
protection technology that is used to
protect content such as 4K movies.
HDMI Section
Connector
Type A (19pin)
USB section
(USB) port:
Type A (For connecting USB memory)
LAN section
LAN(100) terminal
100BASE-TX Terminal
Выходное напряжение:
(ZF9: RU)
Постоянный ток 5 В
Wireless LAN section
Communication system
IEEE 802.11 a/b/g/n
Frequency band (Except Z9F: CH)
2.4 GHz, 5 GHz
BLUETOOTH section
Communication system
BLUETOOTH Specification version 4.2
Output
BLUETOOTH Specification Power
Class 1
Maximum communication range
Line of sight approx. 30 m1)
Maximum number of devices to be
registered
9 devices
Frequency band
2.4 GHz band (2.4 GHz - 2.4835 GHz)
Modulation method
FHSS (Freq Hopping Spread Spectrum)
Compatible BLUETOOTH profiles2)
A2DP (Advanced Audio Distribution
Profile)
AVRCP (Audio Video Remote Control
Profile)
Supported Codecs3)
SBC4), AAC5), LDAC
Transmission range (A2DP)
20 Hz - 40,000 Hz (LDAC sampling
frequency 96 kHz with 990 kbps
transmission)
20 Hz - 20,000 Hz (Sampling frequency
44.1 kHz)
1) The actual range will vary depending on
factors such as obstacles between
devices, magnetic fields around a
microwave oven, static electricity,
cordless phone use, reception
sensitivity, the operating system,
software applications, etc.
2) BLUETOOTH standard profiles indicate
the purpose of BLUETOOTH
communication between devices.
3) Codec: Audio signal compression and
conversion format
4) Abbreviation for Subband Codec
5) Abbreviation for Advanced Audio
Coding
Front L/Front R/Center speaker block
section
Speaker system
Full Range speaker system, Acoustic
suspension
Speaker
46 mm (1 13/16 in.) cone type
General
Power requirements
120 V AC, 60 Hz (Z9F: US, CND)
120 V AC, 50 Hz/60 Hz (Z9F: TW)
120 V - 240 V AC, 50 Hz/60 Hz
(Z9F: EA, LA)
220 V - 240 V AC, 50 Hz/60 Hz
(Z9F: AUS, CH, SP, TH, IND/ZF9)
Power consumption
On: 52 W
[Network/Bluetooth Standby] - [On]:
Less than 2.4 W
[Network/Bluetooth Standby] - [O]:
Less than 0.5 W*
* When [Standby Through] is set to
[O], or [Standby Through] is set to
[Auto] while the connected TV is
turned o.
(Z9F: CH)
(Z9F: CH)
(ZF9: AEP, UK)
• Wi-Fi port and Ethernet port have router
function which can forward audio data to
some other audio product through
BLUETOOTH function.
• When [Network/Bluetooth Standby] or
[Bluetooth Mode] is set to [O], the
wireless LAN, wired LAN and BLUETOOTH
function are disabled in standby mode.
• When [Bluetooth Mode] is set to [O],
BLUETOOTH function is disabled.
柵䋫剧♘
3/5!HI{!.!3/5946!HI{
6/26!HI{!.!6/46!HI{
6/836!HI{!.!6/96!HI{
⌵⭨∃䋫
Ŭ!31!eCn!)FJSQ*!
\3/5 HI{!.!3/5946 HI{^
Ŭ!34!eCn!)FJSQ*!\6/26 HI{!.!
6/46 HI{^
Ŭ!44!eCn!)FJSQ*!
\6/836 HI{!.!6/96 HI{^
⌵⭨∃䋫
Ŭ!31 eCn
FJSQ
– Continued on next page –