2
• Loosen & ghten the ratchet knob to adjust
the blimp handle as per your requirement.
• Next, rotate and open the end cap.
Blimp Assembly
• Once the end cap is aached to the blimp
windscreen, you can cover it using the fur
cover.
NOTE: The fur cover serves the purpose of
further minimizing the noise. You can use 60cm
or 40cm fur cover depending on whether the
blimp is with or without the
extension.
• Open the locking clips at both the ends of the
blimp cage and slide out the mic holder rod.
• Insert dierent holder clamps in the
inseron slots to use other mics with
dierent diameters.
• Insert Mic into the suspension system and
connect it to a connector cable. Then,
re-aach the blimp cage.
• While using the blimp extension, aach the
extension to the blimp and close the blimp
windscreen with the end cap.