Unbranded 87753 User manual

FLOOR REGISTER CARE & USE

CARING FOR YOUR FLOOR REGISTER

Manufacturers at the highest quality standards to create long lasting decorative floor registers.

Proper care and regular maintenance will help to prolong the life of these products.

When cleaning your register, mop or wipe clean with any mild household cleaner that does not contain

bleaching agents.

The grate must then be dried to prevent spotting.

In any high humidity areas, it is recommended to coat your grate with an extra clear coat of oil-based sealer

to prolong the life of your grate.

If you're replacing an existing floor register, be sure to choose one that fits your existing duct opening. Simply

measure the width and length of the duct opening to determine the correct size to purchase.

INSTALLING YOUR NEW FLOOR REGISTER

1. Position the register frame over the duct opening, allowing even spacing on all four sides.

2. Drill a 5/64-inch pilot hole inside the recessed area of the frame at an angle, down into the subfloor.

3. Carefully making sure that the frame has not shifted, use a #6 finishing nail to attach the one corner

to the subfloor. Use a nail set to drive the finishing nail into the recessed wood in order not to

damage the frame with the hammer.

4. Repeat Step 3 so that you have 2 nails per side inside the frame, securing the register to the subfloor.

5. Insert vent cover into the frame.

This manual is also suitable for

Download PDF