Brodit 854772 Datasheet

  • Hello! I am an AI chatbot trained to assist you with the Brodit 854772 Datasheet. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
28 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 854772
854772 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288547725
Item no 854772 fits:
Infiniti JX 12-13 (For USA)
Infiniti QX60 14-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of
adhesive tape on the ProClip. Press the angled edge on the upper part of the ProClip into the seem/gap between
the air vent and the surrounding panel frame.
2. Start with the left corner of the ProClip and then continue to the right until the angled edge is all the way into
the gap.
3. Place your index finger onto the bottom of the ProClip and push so it flexes upward. Push the ProClip a tiny bit
forward and let go of the pressure so the thin end goes into the gap between the air vent and the surrounding
panel frame.
4. The ProClip is in place.
2(2)
/