Cadac 98512 Owner's manual

503-0167 LEV14

USER INSTRUCTIONS

LIVE THE BRAAI LIFE

(SPEC 4) NOTE! PRODUCT MAY VARY FROM ILLUSTRATIONS

GB DE DK ES FR IT NL NO PL SE

MERIDIAN 3 & 4

MODEL No: 98510, 98512,

98522 & 98533

28/37 mbar

MERIDIAN 4

98512

Page is loading ...

11

CAUTION

Provide ample ventilation. This gas appliance consumes air (oxygen). Do not use this appliance in an unventilated space to

avoid endangering your life. If still more gas appliances and/or occupants using gas are added to the space, additional ventilation

must be provided.

IMPORTANT

Read these instructions carefully so as to familiarise yourself with the appliance before ting the appliance to a gas cylinder.

Retain these instructions for future reference.

GB

1. General

• This appliance complies with BS EN498:2012 and SANS 1539:2012

• This appliance may only be used with an approved hose and regulator (A 2.8kPa hose and regulator supplied with this unit in South

Africa)

• The gas cylinder is to be used in the upright position.

• Only to be used with a gas cylinder that does not exceed 500mm in height(Regulator is included) and 400 mm in width.

• Gas appliances require ventilation for efcient performance and to ensure the safety of users and other persons in close proximity.

• Warning: Accessible parts may be very hot. Keep young children away.

• After use, turn off the gas supply at the cylinder, and then at the control knobs.

• When using a pot, the minimum recommended pot size is 150mm and maximum recommended size is 300mm.

• Use outdoors only!

Country of use DK, FI, NO, NL, SE,

AT, SI

BE, ES, FR, IE, IT, PT,

GB, CH

PL

Appliance Catagories I3B/P (30) I3+ (28-30/37) I3B/P (37)

Allowable gases and

operating pressure

Butane @ 28-30mBar

Propane @ 28-30mBar

Butane/Propane mixtures

@ 28-30mBar

(SA - LPG @ 2,8kPa)

Butane @ 28-30mBar

Propane @ 37mBar

Butane @ 37mBar

Propane @ 37mBar

Butane/Propane mixtures

@ 37mBar

Main 3 Burner BBQ unit

(98510, 98522)

Jet number 0.92

Nominal usuage Butane - 233 g/h

per burner

Butane - 233 g/h

per burner

Butane - 276 g/h

per burner

Gross nom. heat input 3.2 kW per burner

(9.6 kW in total)

3.2 kW per burner

(9.6 kW in total)

3.8 kW per burner

(11.4 kW in total)

Gas supply sources:

a) A rellable gas container not exceeding 11kg and complying with local regulation in force.

Main 4 Burner BBQ unit

(98512, 98533)

Jet number 0.92

Nominal usuage Butane - 226 g/h

per burner

Butane - 226 g/h

per burner

Butane - 276 g/h

per burner

Gross nom. heat input 3.1 kW per burner

(12.4 kW in total)

3.1 kW per burner

(12.4 kW in total)

3.8 kW per burner

(15.2 kW in total)

Side Burner (98510, 98512)

Jet number 0.84

Nominal usuage Butane - 211 g/h Butane - 211 g/h Butane - 226 g/h

Gross nom. heat input 2.9 kW 2.9 kW 3.1 kW

1) For gas categories I3B/P(30)

Meridian 3B with side tables, models 98522, total nominal heat input 9.6kW @ 699g/h.

Meridian 4B with side tables, models 98533, total nominal heat input 12.4kW @ 904g/h.

Meridian 3B with side table & side burner, models 98510, total nominal heat input 12.5kW @ 910g/h.

Meridian 4B with side table & side burner, models 98512 total nominal heat input 15.3kW @ 1115g/h.

2) For gas categories I3B/P(37)

Meridian 3B with side tables, models 98250-31, total nominal heat input 11.4kW @ 828g/h.

Meridian 4B with side tables, models 98251-41, total nominal heat input 15.2kW @ 1104g/h.

Meridian 3B with side table & side burner, models 98250-33, total nominal heat input 14.5kW @ 1054g/h.

Meridian 4B with side table & side burner, models 98251-43 total nominal heat input 18.3kW @ 1330g/h.

22

2. Safety information

• The hose and seal on the regulator must be checked for wear or damage before every use

and before connecting to the gas cylinder.

• Ensure the appliance is used away from  ammable materials. Minimum safe distances are

1.2m above the appliance and 600mm to the rear and sides of the appliance.

• Do not use an appliance that is damaged, leaking, or which does not operate properly.

• Keep gas cylinders away from heat and  ames. Do not place on a stove or any other hot

surface.

• Ensure that the assembled unit is stable and does not rock.

• Do not cover or change the primary air supply openings in the burners as this will affect the

performance of the product and may lead to an unstable  ame.

• In the event of burn back, (where the  ame burns back and ignites at the jet), immediately

turn off the gas supply by  rst closing the control valve on the gas cylinder and then

the appliance valve. After the  ame is extinguished remove the regulator and check the

condition of its seal. Replace the seal if in doubt. Re-light the appliance as described

in Section 3 below. Should the  ame light back persistently return the product to your

authorized CADAC repair agent.

• If there is a leak on your appliance (smell of gas), immediately close the control knob on

the gas cylinder. If you wish to check for leaks on your appliance, do it outside. Do not try

to detect leaks using a  ame; use soapy water.

• The correct way is to smear the joints with soapy water. If a bubble or bubbles form then

there is a gas leak. Immediately turn off the gas supply  rstly by closing the control valve

on the gas container and then the appliance valve. Check that all the connections are

properly  tted. Re-check with soapy water. If a gas leak persists, return the product to your

CADAC dealer for inspection / repair.

• Do not modify the appliance or use it for anything which it has not been designed for.

• During use, part of the appliance will become hot, particularly the cooking areas and

the hood. Avoid touching hot parts with your bare hands. The use of oven gloves is

recommended.

• Keep young children away from the appliance at all times.

• This appliance consumes oxygen and needs ventilation for optimum performance and for

the safety of those in close proximity.

• Do not move the appliance while in use.

• The parts sealed by the manufacturer or its agent must not be altered by the user.

NOTE

• Do not twist or pinch the hose. Ensure that it is kept away from the BBQ body so as to

prevent deterioration/damage to the hose caused by heat.

• Fit one end of the low pressure hose onto the regulator nozzle, and the other end onto the

Patio BBQ nozzle by pushing the ends on as  rmly as possible. Clamp into position using a

hose clamp at both ends of the hose.

• Ensure that the connections are made securely and do not allow gas to leak.

• Check for gas leaks before using the appliance.

• For use with an approved hose and regulator connected to a re llable gas container not

exceeding 9kg and complying with local regulation in force.

• Do not obstruct the ventilation openings of the cabinet.

• Do not modify the appliance. Modifying the appliance may be dangerous.

• Warning: Since this barbecue has no restriction in the emission of unburned gas, this

barbecue must be installed and/or used OUTDOORS or in an AMPLY VENTILATED AREA.

Ensure this BBQ is installed in an AMPLY VENTILATED AREA, the area must have at least

25% of the surface(sum of the walls surface) area open.

• Do not move the appliance during use.

• Any modi cation of the appliance may be dangerous.

• Warning: An LP cylinder not connected for use, shall not be stored in the vicinity of this or

any other appliance.

GB

33

4. Fitting and Changing the Gas Cylinder

• Before connecting the appliance to a gas cylinder, ensure that the rubber seal on the regulator is in position and in good condition.

• Carry out this check each time you t the appliance to a gas cylinder.

• Blow out any dust from the cylinder opening to prevent possible blockage of the jet.

• Ensure that the appliance valves are in the off position by turning the knobs fully clockwise to their stop.

• Ensure that the gas cylinder is tted or changed in a well-ventilated location, preferably outdoors, away from any source of

ignition, such as naked ames and away from other people.

• Make sure that the gas cylinder is kept upright at all times. Hand tighten the regulator onto the cylinder until it is fully engaged.

• If there is a leak on your appliance (smell of gas), extinguish all sources of ignition in the vicinity of the appliance. If you wish to check

for leaks on your appliance, use soapy water which is applied to the suspected area. A formation of bubbles will indicate a gas leak.

Check that all the connections are securely tted and re-check with soapy water. If you cannot rectify the gas leak, do not use the

appliance. Contact your local CADAC stockist for assistance.

• When changing a gas cylinder, rst close the cylinder valve and then the appliance valve, making sure the ame is extinguished and

unscrew the regulator. Re-t the regulator to a full cylinder following the same precautions as described above.

• After the appliance has been fully assembled, perform a gas leak test before operating the appliance.