Hifonics BRX12D4 Owner's manual

Hifonics
Brand
Hifonics
Model
BRX12D4
Category
Car subwoofers
Type
Owner's manual
BRX12D4
SUBWOOFERS
BRUTUS
1
BRUTUS SERIES
CAR AUDIO SUBWOOFERS
Congratulations on your purchase of the new Hifonics BRUTUS
Series subwoofer. The BRX subwoofers have been built for
stunning sound quality as well as powerful bass.
As with all high quality car audio products, we recommend
professional installation by an authorized Hifonics dealer.
Your dealers knowledge and experience can ensure a problem
free and cosmetically integrated installation.
If you choose to install the subwoofers yourself, please read the
entire manual very carefully.
12” Round Subwoofers
Heavy Duty Woven Texture Polypropylene Cone &
Injection Molded Dust Cap
ABS Trim Ring With Illumination
UV Resistant Butyl Rubber Surround
Dual Resin Infused Textile Spiders
Powder Coated Deep Draw Stamped Steel Basket
2.5” High Temp Voice Coil
DVC 4-Ohm
Push & Insert Style Speaker Terminals
56 oz Vented Motor
Heavy Duty ABS Protective Motor CAP
For product videos and great tutorials, check out
www.youtube.com/maxxsonicsusainc
2
DVC 4-Ohm Coil Wiring
-
+
SERIES COILS
1+ 1-
2- 2+
8-Ohms
SERIES COILS / PARALLEL SUBS
1+ 1-
2- 2+
-
+
-
+
1+ 1-
2- 2+
2.66-Ohms
-
+
1+ 1-
2- 2+
1 2
3
SERIES COILS / PARALLEL SUBS
1+ 1-
2- 2+
-
+
-
+
1+ 1-
2- 2+
2-Ohm
1 2
-
+
1+ 1-
2- 2+
3
-
+
1+ 1-
2- 2+
4
PARALLEL COILS
-
+
1+ 1-
2- 2+
2-Ohms
1+ 1-
2- 2+
SERIES COILS / PARALLEL SUBS
-
+
-
+
1+ 1-
2- 2+
4-Ohms
1 2
PARALLEL COILS / PARALLEL SUBS
1+ 1-
2- 2+
-
+
-
+
1+ 1-
2- 2+
1-Ohm
1 2
ILLUMINATION WIRING
+
SMALLER
PUSH
&
INSERT
TERMINALS
-
1. Connect the LED + RED terminal to an accessory
switched 12 volt wire. This wire should have +12V
when the ignition key is “on” and 0 volts when the
ignition key is “off”. You can use a toggle switch
in line on this wire to manual turn the illumination
off if desired and this 12V+ wire must have a 5 amp
fuse in line.
2. Connect the LED - BLACK terminal to chassis ground.
3
4
Q The energy losses of relative damping (ratio of stored to dissipated
energy or ratio of reactive to resistive energy).
Fs Free air resonance of driver in Hz.
Qms Mechanical Q.
Vas Volume of air equivalent to driver from the rest position.
Cms Mechanical compliance of a loud speaker piston.
Mms Moving mass of total loud speaker piston assembly.
Xmax The maximum linear excursion of a loud speaker.
Sd Surface area of the cone.
Dia The piston diameter of a loud speaker.
Qes Electrical Q of a system.
Re DC resistance.
Le VC inductance.
Pe Maximum input power.
Qts Total Q of the system.
Sens Sensitivity. An efficiency measurement in dB’s.
Vc Volume of a closed or sealed enclosure
Vb Volume of a vented enclosure.
Fc The resonant frequency of a closed or sealed system
Fb The resonant frequency of a vented system
F3 The half-power (-3dB) frequency of a loud speaker enclosure
Qtc The Q of a loud speaker at Fc in a closed box, considering both
it’s electrical and mechanical resistance.
QL The Q of a vented box, resulting from all box losses.
DV Diameter of vent.
LV Length of vent.
H Height.
W Width.
D Depth
Glossary of Terms
5
Subwoofer Dimensions
278mm / 10.94”
326mm / 12.83”
144.5mm / 5.69”
185.6mm / 7.31”
PART #: F113
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Hifonics BRX12D4 Owner's manual

Hifonics
Brand
Hifonics
Model
BRX12D4
Category
Car subwoofers
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents