Page is loading ...
LET’S GET STARTED.
QUICK AND EFFORTLESS IRONING
ICC1V1EP
PowerShot
Let’s talk safety
Basic
safety
precautions
This iron is intended for domestic use only and NOT for commercial
or industrial use.
• Only use the iron indoors and keep the area you’re ironing well lit.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied persons
in order to avoid a hazard.
• Keep the iron and its cord out of reach of children less than
8 years of age when it is energised or cooling down.
• This iron can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use
of the appliance in a safe way and understand the hazards involved. Children
shall not play with the iron. Cleaning and user maintenance shall not be made by
children without supervision.
Don’ts
• Don’t touch any hot areas on your iron. The soleplate on the iron
can become extremely hot and may cause burns if touched.
• Don’t leave the iron unattended while it is connected to the mains
and before it has cooled down.
• Don’t use the iron if has been dropped, damaged, immersed
in water, left outdoors or has any visible signs of leaking.
• Don’t hold the iron under a running water tap, always use a jug to ll.
• Don’t touch the power cord with the irons soleplate.
• Don’t use the iron if the power cord or plug is damaged.
• Please contact our Customer Care Line on: 0330 026 8455
(Mon-Fri 8:30am to 6:30pm, Sat 9:00am to 5:00pm)
• Don’t handle the plug or use the iron with wet hands.
• Don’t pull or carry the iron by the power cord.
• Don’t use the power cord as a handle, pull the power cord around corners or
sharp edges or close a door over the power cord. Don’t unplug the iron by pulling
on the power cord.
• Don’t aim the steam jet at people, animals, plants and electrical components
or wires. Never touch the steam jet (there is a risk of scalding).
• Don’t use the iron with incorrect voltage as this may result in damage or injury
to the user. The correct voltage is listed on the ratings label.
• Don’t use the iron on clothing that are still being worn on the body.
• Don’t open the lling aperture during use.
Do’s
• Always switch o, unplug from mains and allow the iron to cool
down before carrying out any maintenance or troubleshooting.
• Always stand the iron in the upright position between uses and
keep the iron moving whilst in use. Leaving the soleplate in contact
with any surface for an extended period of time will cause damage.
• When placing the iron on its stand, ensure that the surface on
which the stand is placed is stable.
• Always use the iron on a heat resistant, stable, level surface.
• Always unplug the iron from the mains before the water tank is
lled with water.
• Always ll the water tank with water only. Never add perfume,
descaler or products containing alcohol. Filling the water tank with
hot or boiling water will invalidate the warranty.
• Always ensure the soleplate and surfaces are free from grit and debris before use.
• Always carry the iron by the handle.
• Always empty the water tank when the iron is not in use.
• Always replace the fuse in the plug with a British 13amp fuse. Always protect
the power cord from heated surfaces or near open ames.
• Use only CE approved 13amp extension cords, non-approved extension cords
can overheat. Care should be taken to arrange the extension cord as it could be
a trip hazard.
• Before storing make sure the iron has fully cooled, the water tank is empty
and wrap the power cord around the iron. Store the iron in a cool, dry area
away from children.
Please keep instructions for further use and use only as instructed in this guide.
Contents
Power Shot
Let’s talk safety
Getting to know your appliance
Getting started
Using your appliance
Taking care of your machine
Cleaning and maintenance
Notes
What to do if it goes wrong
Getting in touch
Included with
your iron
Jug
Thank you for buying this Vax Steam Iron.
Taking care of your ironing.
The Vax Steam Iron is designed to make ironing regularly, as eective and ecient as possible
and this user guide will help you get the most out of your steam iron.
Taking care of your Steam Iron
Also inside this guide are instructions on maintaining your new Vax Steam Iron, so that it’s
always ready when you are to tackle your creases.
Let us know what you think @VaxUK
Taking care of you
We’re here if you need us. Instead of taking me back
to the shop, simply visit:
vax.co.uk/support or call:
(UK) 0330 026 8455 (ROI) 1-800 928 308
Monday-Friday 8:30am to 6:30pm, Saturday 9:00am to 5:00pm
Calls are charged at the UK local rate. Please make a note of the serial number and model number
of the product before calling.
Alternatively, you can write to us at:
Vax Ltd., Plot 302, Stonebridge Cross Business Park, Hampton Lovett, Droitwich, WR9 0LW, UK
This user guide can be found online at: vax.co.uk/support
Getting to know your appliance Getting started
Filling the water tank
With the iron disconnected
from the mains open the
water ll cover.
Tilt the iron forwards.
Using the jug provided ll
the water tank up to the
Max ll line.
Close the water ll cover.
Before you begin
CAUTION: The soleplate becomes very hot during use. Always allow the iron to cool down before carrying out any
maintenance or trouble shooting. Do not use hot or boiling water to ll the water tank. Don’t over ll the water tank
or exceed the maximum amount required. Always unplug from the mains before topping the tank up with water.
Always switch o the iron and allow to cool before emptying the water tank.
IMPORTANT: When using the iron basic safety precautions should always be observed.
Don’t aim the steam jet at people, animals, plants and electrical components or wires. Never touch the steam jet
(there is a risk of scalding).
Before rst use remove labels and all packaging.
Always make sure the water ll cover is closed correctly before use.
NOTE: The iron can be lled with tap water. For hard water areas we recommended the use of distilled or
demineralised water. Half ll the water tank with distilled or demineralised water and top up to the ‘Max’ line
with tap water.
Do not add perfume, vinegar, starch, descaling agents, ironing aids or other chemicals to the water tank.
When lling make sure the appliance is unplugged.
Technical Specication
Name Power Shot
Model number ICC1V1EP
Power input Please refer to rating label
Tank capacity 300ml
Weight 1.1kg
Subject to technical change without notice.
Steam boost button Heating Indicator Light
Self clean button
Water tank
Spray burst button
Steam control
Soleplate
Power cord
Handle
Temperature
control dial
Spray
burst nozzle
Water ll cover
Getting started
Preparing for use
Always check the laundry care label and adjust the temperature and steam accordingly for the type of fabric.
Test on a hidden area to begin with.
The spray burst will
moisten the fabric to help
remove stubborn creases.
The steam boost function
can be used to iron in the
vertical position to remove
creases from hanging
clothes and curtains.
The steam boost function can only be used at
temperature settings between
and Max
to help remove stubborn creases.
Press and release the
spray burst button.
Press and release the
steam boost button.
Stand the iron in the
upright position on a heat
resistant levelled surface.
Select to the
required temperature
using the temperature
control dial.
Select the required steam
setting. Make sure the
steam setting selected is
suitable for the ironing
temperature.
Plug into mains, the
heater indicator light
will illuminate. When
the selected temperature
has been reached the
light will go out.
Features
Using your appliance
NOTE: The indicator light will illuminate intermittently during ironing.
Spray burst
Vertical steam boost
Steam boost
The anti-drip function
stops drops of water
falling onto your
clothes when ironing
at low temperature.
Anti-drip
Fabric type Temperature setting Steam setting Steam boost Spray burst
Cotton/linen Adjustable Yes Optional
Silk/wool N/A No Optional
Synthetics N/A No Optional
Cleaning and maintenanceTaking care of your appliance
Self clean
Emptying the water tank
Storing
Tilt the iron forwards.
Using the jug provided ll
the water tank up to the
Max ll line.
With the iron disconnected
from the mains and
completely cooled down
open the water ll cover.
To prolong and for best continued performance of the appliance, use the self clean function once every two weeks.
In hard water areas, the self clean function should be used more frequently.
Wrap the power cord
around the iron.
Select the Max temperature
using the temperature
control dial.
Empty the water tank
over a sink.
Store the iron in the
upright position, in a dry,
safe place.
Select NO steam
on steam control by
moving steam control
to the left.
Close the water ll cover.
Plug into mains, the
heater indicator light
will illuminate. When the
selected Max temperature
has been reached the light
will go out.
CAUTION: Always unplug the appliance from the mains and allow to completely cool down in a safe place before
carrying out any maintenance or troubleshooting checks. Do not leave water in the water tank between uses, as
this can eect the irons performance. The water tank should be emptied after each use.
Unplug the appliance from
the mains and hold the
iron over a sink.
Press and hold down
the self clean button
and gently shake the iron.
Release the self clean
button after 5-10 seconds.
Repeat the process
again until all the
impurities and akes
are ushed out from
the iron.
TIP
Your Vax iron contains an
anti-calc cartridge which
helps to reduce scale
deposits and helps to
maintain the performance of
your iron. It does not need
to be replaced.
NotesCleaning and maintenance
Cleaning the soleplate
Tilt the iron forwards.
Using the jug provided ll
the water tank up to the
Max ll line.
After carrying out the self clean process always clean the soleplate, making sure any water stains or impurities that
may have formed are completely removed.
Select the Max temperature
using the temperature
control dial.
Select NO steam on
steam control by moving
steam control to the left.
Plug into mains, the
heater indicator light
will illuminate. When
the selected Max
temperature has been
reached the light will
go out.
Unplug the appliance
from the mains. Move the
hot iron over a piece of
used cloth to remove any
water stains/impurities
from the soleplate.
Allow the iron to
completely cool down
in a safe place before
emptying the water
tank and storing.
CAUTION: Do not use abrasive or scowling materials as they will scratch the plate.
SolutionProblem
• The plug may not be fully pushed into the electrical socket.
• Check the fuse in the plug. If this needs replacing, always use
a British 13amp fuse.
The iron has no power.
• There may be no water in water tank, ll the water tank.
• The temperature control dial or steam control has not been set
to the appropriate settings. Go to ‘Preparing for use’.
• The iron has a build up of limescale, Go to ‘Cleaning and maintenance –
self clean’.
Why is the iron not
producing steam?
• The steam boost button has been pressed too often within a short period.
Continue ironing in a horizontal position, after a short period of time use the
boost button again.
• The temperature control dial has not been set at a temperature the steam
boost function can be used (
to Max). Stand the iron in the upright
position, adjust the control dial and wait for the heating indicator light to go
out before using the steam boost.
Why is the steam boost
not working?
What to do if it goes wrong
Why is the spray
burst not working?
• The water tank is not full enough. Unplug the iron from the mains and add
water to the water tank.
Water is leaking
from the iron.
• The water ll cover is not correctly closed. Close the water ll cover.
• The steam boost button has been pressed with the control dial set at
the incorrect temperature. The steam boost function can be used
(
to Max).
• Excessive use of the steam burst button can reduce the temperature
of the soleplate temporarily meaning that it will need to heat up again.
If this happens the water may potentially pool in the ‘boiler’.
†
Registration required. Terms and conditions apply, see vax.co.uk for details.
* Calls are charged at the UK local rate. Please make a note of the serial number and model number of the appliance before calling.
Getting in touch
GET IN TOUCH
0330 026 8455 VaxVacuums[email protected] vax.co.uk @VaxUK
EEC Statement of Compliance: Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the
ICC1V1EP is manufactured in compliance with the following Directives: Safety: 2014/35/EU Low Voltage Directive.
EMC: 2014/30/EU Electromagnetic Compatibility Directive.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
© 2016 Vax Limited. All rights reserved. The VAX trade mark and Vax lozenge are the property of Techtronic Floor Care
Technology Ltd and are registered in the EU and may be pending or registered in other countries.
/